Miele KF 3855 S6 Operating And Installation Manual page 38

The appliance can be installed into a
kitchen run. To match the height of the
rest of the kitchen the appliance can be
fitted with a suitable top box a.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance for air to circulate.
The cross section of the air outlet must
be at least 300 cm
can circulate without hinderance. Oth-
erwise the appliance has to work too
hard resulting in an increase in electric-
ity consumption.
38
2
to ensure that air
The air inlet and outlet must not be
covered or blocked in any way.
They should be dusted on a regular
basis.
When built into a kitchen run (max.
depth 580 mm) a spacer trim of at least
10 mm must be fitted at the side. If a
decor panel is also fitted the thickness
of the panel (max 4 mm) must be taken
into consideration to ensure the appli-
ance door can open and shut without
hinderance.
When
tance of approx. 50 mm is needed on
the hinge side between the wall and the
appliance, so that the doors and the
handles have sufficient space for open-
ing.
When
d or if is fitted between the
appliance and the wall, please note the
following:
^ Ensure that the doors have sufficient
space for opening fully after the ap-
pliance has been secured.
^
would damage insulated parts of the
appliance.
^ To secure the appliance to adjoining
kitchen furniutre use self tapping
screws. The
not exceed
d a dis-
as this
of the screw must
.