Advertisement
^ Open the appliance door, tilt it
downwards and take it off.
^ Remove cover f, and unscrew hinge
bracket g.
^ Fit hinge pin h in the second hole of
hinge bracket g.
^ Refit bracket i and cover j turned
through 180° on the opposite side.
^ Screw hinge bracket g into the
opposite side.
The
the left hole of the hinge bracket.
^ Turn cover f through 180°, and fit it
on the other side.
^ Remove spacer k with a screwdriver
and refit it on the opposite side.
^ Remove plug l from the door
bearing bush in the door and refit on
the opposite side.
^ Unscrew tappet m.
34
has to be screwed into
Keep it in a safe place just in case
you ever decide to change the door
hinging back to right hand hinging.
^ Screw the tappet supplied n into the
opposite side using the same screw
o.
^ Hang the door on hinge pin h and
then close the appliance door.
In the following illustration the door
is not shown in the closed position to
make it easier to see what happens
next.
^ Turn door support b around, pull
hinge pin a out, and refit on the
opposite side.
^ Fit both parts into hinge plate f. To
do this push hinge pin a through
hinge plate f into door support b.
Swing the door support in, push
upwards and re-assemble with screw
c.
Advertisement
