General Problems - Miele G 1570 Operating Instructions Manual

Problem solving guide

General problems

Problem
The In-operation
indicator is flashing
quickly.
The "Check spray
arm" indicator
flashes when the
door is open.
Detergent residue is
left in the dispenser
at the end of a
programme.
The detergent lid
cannot be closed
properly.
At the end of a
programme there is a
film of moisture on
the inside of the door
and the interior walls.
Water remains in the
wash cabinet at the
end of a programme.
52
Possible cause
Items are blocking
the path of the middle
spray arm.
The middle spray arm
jets are blocked.
The dispenser was
still damp when
detergent was added.
Clogged detergent
residue is blocking
the catch.
This is caused by the
drying system and
does not indicate a
fault.
The filter combination
in the wash cabinet is
clogged.
The drain pump or
non-return valve may
be blocked.
The drain hose is
kinked.
Remedy
Open the dishwasher door and
rearrange the items which are
obstructing the spray arm.
– Switch the dishwasher off with
the Off button o.
Then:
– Clean the spray arm. See
"Cleaning and care".
Make sure the dispenser is dry
before adding detergent.
Clean the detergent from the
catch.
The moisture will dissipate after a
short while.
Before rectifying the problem you
must:
– Switch the dishwasher off with
the Off button o.
Clean the filter combination. See
"Cleaning and Care".
Clean the drain pump or the
non-return valve. See "Problem
solving".
Remove any kink from the drain
hose.