Table of Contents
Advertisement
After each bank is loaded, you should see the message "Verify complete".
The procedure will continue, and finally end with the prompt and cursor:
If any of the banks indicate an error during the erase, verify, or programming phases,
IMMEDIATELY repeat the operation "loadflash Enter" without doing any other operation.
If the procedure still fails, perform this entire procedure again up to ten times. Should you
still encounter a problem, please contact 360 Systems technical support. If you need to continue
using the system right away you can restart using the Quick Restart procedure
(Start>Shutdown>Quick Restart) and operate with the existing firmware as the new firmware will
not be loaded until power is cycled.
36
2470HD Time Delay
Advertisement
Table of Contents
Need help?
Do you have a question about the Maxx 2470-HD and is the answer not in the manual?
Questions and answers