Using With The Alkaline Battery - Sharp WA-MP50H Operation Manual

Using with the alkaline battery

WA-MP50H
! Inserting the battery
1
Open the battery cover.
2
Insert the "AAA" size alkaline battery (LR03) into
the battery compartment.
3
Close the battery cover.
Do not force the battery
cover open too far.
Notes:
" Do not replace the battery during operation.
" Do not use a nickel-cadmium battery.
" Remove the battery if the unit will not be used for long
periods of time. This will prevent potential damage due
to battery leakage.
" Installing the battery incorrectly may cause the unit to
malfunction.
Battery removal:
Open the battery cover and pull the battery.
7
WA-MP50H TINSEA075SJZZ
! Checking the remaining amount of battery
level
The battery level is shown by the battery indicator during
operation.
03
When the battery
level is high
Insert
" When the battery level is very low, the battery indicator
the side. will flash. Replace the alkaline battery with a new one.
" When the battery has run out completely, "Low Battery
Shut Down..." will appear. Then, the power will be dis-
connected automatically.
Notes:
" The battery indicator will not correctly display the
remaining capacity for approximately 10 seconds after
the power has been turned on.
" The number of bars shown in the battery indicator may
increase or decrease, depending on the operation
being performed. This is normal.
" The battery life and the operating time may be short-
ened by usage conditions, long periods of disuse, etc.
Battery indicator
When the battery
level is very low
05/8/4 WA-MP50H_SCA.fm