When The Jw-50Fl Is Used - Sharp JW-20FL5 User Manual

Chapter 12: Parameters

[2] When the JW-50FL is used

Set the parameters for the JW-50FL in the system memory of the control module. Select the
parameter (system memory) area using the SW3 switch on the JW-50FL.
(Details
Switch SW3 setting
Parameter address
(system memory)
Note: Do not set switch SW3 outside the range of 0 to 4.
- Relationship between the host PC and the control module
FL-net module
- How to set the parameters using the JW-14PG
This paragraph describes param-
eter setting procedures (in system
memory) using the handheld JW-
14PG programmer.
1 Connect the JW-14PG to the
support tool connector on the
control module.
2 Set the PC to program mode.
3 Set a start switch to 00
12
4 Enter the IP address (192.168.250.3) at parameter addresses 00 to 03
Same as the above, enter the other parameter addresses.
See the next page. Switch SW3
0
#0300 to
(8)
#0377
Host PC
JW50H
JW70H
JW-50FL
JW100H
.
(H)
Read parameter
address 77
memory #0377 *).
* When switch SW3 is
set to 0.
See page 4-4.)
1 2
#1400 to #1500 to
#1477 #1577
Control module
JW-50CUH
JW-70CUH
JW-100CUH
JW-14PG
Connection cable
(ZW-3KC)
(system
(8)
Decimal display of the setting
12-4
3 4
#1600 to #1700 to
#1677 #1777
(The modules shown below
are installation examples)
JW-50FL
Control module (JW-100CUH)
JW-14PG screen
#0375 HEX 00
#0376 HEX 00
P System
>#0377 HEX 00
.
(8)
#0301 DCM 168
#0302 DCM 250
P System
>#0303 DCM 003