Adjusting The Machine Head Angle; (Direct-Drive Motor Type Sewing Machine Only) - JUKI IP-110 Type F Instruction Manual

Hide thumbs Also See for IP-110 Type F:

Table of Contents

4. aDJuStING tHE MacHINE HEaD aNGLE

aDJuStING tHE MacHINE HEaD aNGLE

warNING :

Be sure to perform the angle adjustment of the machine head by the operation below before using

the machine head.

[Machine head angle adjusting screen]

) Keep�g swtch 1 held pressed, tur� the power

2) Tur� the mach�e head pulley by ha�d u�tl the

3) �� ths state, alg� the whte dot 2 of the ha�d-

4) O�ce the a�gle s determ�ed, press swtch 4 .

- 3 -

ON. The� the scree� s cha�ged over to the

mach�e head a�gle adjust�g scree�.

ma� shaft refere�ce sg�al s detected. The�,

the a�gle tra�smtted by the ma� shaft refere�ce

sg�al s dsplayed � reverse vdeo. (The value

shown in the figure is a value for reference.)

wheel wth the co�cave 3 of the ha�dwheel

cover as shown in the figure.

The a�gle dsplayed � reverse vdeo s �ow ds-

played � �ormal vdeo a�d the a�gle s replaced

by the adjusted o�e. Tur� the power swtch OFF

to ext from the a�gle adjustme�t.

Table of Contents

Do you have a question about the IP-110 Type F and is the answer not in the manual?

Sc-920