Walter Meier is consistently adding new products to the line. For complete, up-to-date product information, check with your local Walter Meier distributor, or visit waltermeier.com. WARRANTY JET products carry a limited warranty which varies in duration based upon the product (MW = Metalworking, WW = Woodworking). WHAT IS COVERED? This warranty covers any defects in workmanship or materials subject to the exceptions stated below.
Table of Contents Warranty and Service..........................2 Table of Contents ..........................3 Warning .............................3 Safety Rules for the AFS-2000 ......................5 Introduction ............................5 Specifications .............................5 Electrical Requirements ........................6 Unpacking ............................7 Contents of Shipping Carton ......................7 Assembly ............................7 Controls and Features.........................8 Changing the Filters ..........................8 Parts Breakdown ...........................
Page 4
14. DON’T OVERREACH. Keep proper footing and balance at all times. 15. MAINTAIN TOOLS IN TOP CONDITION. Keep tools sharp and clean for best and safest performance. Follow instructions for lubricating and changing accessories. 16. DISCONNECT TOOLS before servicing and when changing filters. 17.
Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for a JET Model AFS-2000 Air Filtration Unit. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown.
Electrical Requirements Electrical connections must be made by a qualified electrician in compliance with all relevant codes. This machine must be properly grounded to help prevent electrical shock and possible fatal injury. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock.
Unpacking Contents of Shipping Carton Air Filtration Unit Remote Control AAA Batteries Eye Bolts, Washers and Hex Nuts Owner's Manual (not shown) Warranty Card (not shown) Tools Required for Assembly 10 mm Wrench Figure 1 • The air filtration unit does not require muc h assembly.
Controls and Features Remote Control: Time button (A, Figure 3) controls the three different settings. 2H will light up on the back of the unit with one press of the time button. The air filtration system will operate for 2 hours then shut off. 4H will light up on the back of the unit by pressing the time button twice.
Page 9
Inner Filter: You must remove the two bolts (A, Figure 5) that hold the cover in place. Remove the cover. Remove the inner filter (A, Figure 6) from the side of the cabinet. Replace the cover and four bolts. Accessory Filter: An additional electrostatic filter can be added to this empty slot (B, Figure 6).
Need help?
Do you have a question about the AFS-2000 and is the answer not in the manual?
Questions and answers