GAS FURNACES
RGLH- SERIES
Models with Input Rates from
50,000 to 150,000 BTU/HR
[15 to 44 kW]
ENER
UIDE
AFUE
Annual Fuel Utilization Efficiency -
THIS MODEL
80.0%
MID
HIGH
78%
82%
88%
97%
CRITERION
80.0-82.2% A.F.U.E.
DOWNFLOW
GAS FURNACES
The Rheem
®
Criterion
®
II line of downflow gas furnaces is
designed for installation in closets, alcoves, utility rooms, or
attics. The design is certified by CSA.
Features
Patented heat exchanger, constructed of both stainless
and aluminized steel for the maximum in corrosion
resistance.
Low profile "34 inch" [864 mm] design is lighter and easier
to handle, and leaves room for optional equipment.
Left or right side gas and electric inlet connections with
quick, simple change.
Direct Spark ignition models and integrated board with
humidifier and electronic air cleaner hookups.
Insulated blower compartment helps to reduce jacket loss
and noise.
Pre-paint galvanized steel cabinet.
Molded permanent filter.
Grab-holes in doors to aid in easy door removal and
replacement.
A variety of cooling coils and plenums designed to use with
Rheem Criterion II gas furnaces are available as optional
accessories.
A.F.U.E. (Annual Fuel Utilization Efficiency) calculated in accordance with Department of
Energy test procedures.
FORM NO. G11-449 REV. 6
Supersedes Form No. G11-449 Rev. 5
®
II
Need help?
Do you have a question about the CRITERION II and is the answer not in the manual?
Questions and answers
Does my furnace have an electronic ignition for the pilot light
Yes, the Rheem Criterion II furnace has a hot surface ignition (HSI) system, which is an electronic ignition method. It does not use a standing pilot light but instead relies on an HSI to ignite the burners.
This answer is automatically generated
이 기종에 오류코드를 좀 알 수 있을까요? 파워버튼은 들어오는데 ok버튼이 두 번씩 깜빡거립니다.
The error codes for the Rheem Criterion II furnace include the following:
1. 1 blink followed by a 2-second pause – 1-hour lockout
2. 2 blinks followed by a 2-second pause – Pressure switch is open
3. 3 blinks followed by a 2-second pause – Limit switch is open
4. 4 blinks followed by a 2-second pause – Pressure switch closed
5. 5 blinks followed by a 2-second pause – Additional code for deluxe models with twinning capabilities
If the OK button blinks twice, it indicates that the pressure switch is open.
This answer is automatically generated
이 기종의 오류코드를 알고 싶습니다. 파워버튼은 정상작동하나 ok버튼이 깜빡거립니다.