Mounting Bracket
U-Bolt
Use the U-Bolt, Mounting
Bracket, Washers, and
Nuts to attach the Outdoor
mast about 12 inches
below the antenna (not
included).
Use the Coaxial Cable without
Weather Boots to connect the Outdoor
TO POWER SUPPLY
FROM AMPLIFIER terminal.
Feed cable slack into the house and
secure the cable to the mast with twist
ties (not included).
Connect your TV or receiver to the
TO TV terminal.
• Adjust GAIN towards MIN or
MAX for best reception. The
optimum setting depends on
the location, cable lengths,
and number of connected
devices.
• Adjust FM TRAP so that there
is no interference with your
TV signal (no wavy lines on
theTV screen).
The caution marking is located on the bottom of the
Protect the environment by recycling used
electronics. Go to www.ecyclingcentral.com
a recycle location near you.
©2008. RadioShack Corporation.
All rights reserved. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
TV-FM Antenna-Mounted High-Gain
Signal Amplifier
Nuts and Washers
Coaxial
Coaxial
Cable
Cable with
without
Weather
Weather
Boots
Boots
Note: If you are using a splitter to power several devices,
LED Indicator
WARNING:
product to rain or moisture.
This symbol is
This symbol
CAUTION
intended to alert
is intended to
you to the presence
RISK OF ELECTRIC
inform you that
SHOCK DO NOT OPEN
of un-insulated dangerous
important operating and
voltage within the product's
maintenance instructions
CAUTION: To reduce
enclosure that might be
the risk of electric
are included in the
shock, do not remove
literature accompanying
cover or back. No user-
constitute a risk of electric
this product.
serviceable parts inside.
shock. Do not open the
Refer servicing to
product's case.
15-2507
Matching Transformer
Use the Coaxial Cable with
Weather Boots to connect
TO
ANTENNA terminal and the
antenna. If necessary, use the
Matching Transformer.
Slide the weather boots snugly
over the connectors.
Connect to AC power.
The indicator lights.
Mount the
to a wall with
the screw.
and the devices.
Limited Warranty
RadioShack
RadioShack
RadioShack
RadioShack
RadioShack
Thank you for purchasing your TV-FM Antenna-Mounted
RadioShack. Please
read this user's guide before installing, setting up, and
What's Included
Frequently Asked Questions
GAIN
FM TRAP
GAIN
FROM AMPLIFIER
Specifications
Frequency Response ..................... 20dB Attenuation at 100MHz
Gain 30dB.................................................................. (VHF or UHF)
Gain Control.................................................................... 0 to 10dB
Actual product may vary from the images found in this document.
RF Emissions Information
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult your local RadioShack store or an experienced radio/TV
technician for help. If you cannot eliminate the interference, the FCC
requires that you stop using your product. Changes or modifications
not expressly approved by RadioShack may cause interference and
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
02A08
15-2507
AO0203AEA1
Printed in China
Need help?
Do you have a question about the 15-2507 and is the answer not in the manual?
Questions and answers