Setting The Color System - Pioneer PDP-502MX Manual

Menu Mode

2) Setting the color system

INPUT 1 and 2 support all the various formats used in worldwide, which they distinguish between automatically.
CAUTION
This unit is not compatible with PAL-M or PAL-N.
Normally, COLOR SYSTEM:AUTO is set for distinguishing automatically, but occasionally there may be instances of
faulty playback, "no color", etc., as in cases of VTR signals from multifold-generated copy of VTR signals.
In such a case, set as follows, according to the input signal.
Carry out the setting for either INPUT 1 or 2.
For NTSC signal input
For PAL signal input
For SECAM signal input
For 4.43 NTSC signal input = set COLOR SYSTEM : 4.43 NTSC
If you know what the previously input signal was, a fixed setting can be used for smooth signal handling; this can
shorten signal-switching time and prevent errors in distinguishing signals.
Set-able condition:
Factory preset:
1 Select SET UP.
Screen 1
MAIN MENU
PICTURE
SCREEN
ALL RESET
POWER SAVE
3SET UP
MENU : MENU OFF
5∞ 3
: SELECT
98
= set COLOR SYSTEM : NTSC.
= set COLOR SYSTEM : PAL.
= set COLOR SYSTEM : SECAM
INPUT 1 or 2
INPUT 1 : AUTO
INPUT 2 : AUTO
CONTRAST : 0
: 0
BRIGHT
: 0
COLOR
: 0
TINT
: 0
SHARP
RESET
SET : NEXT
2 Move the cursor to COLOR SYSTEM, and press
the SET button to change the setting.
Pressing the SET button moves the settings
through the sequence AUTO=NTSC=PAL=
SECAM=4.43 NTSC=···.
Screen 2
SET UP
3COLOR SYSTEM : AUTO
3D Y/C MODE : MOTION
HIGH CONTRAST : OFF
EXIT
5∞ 3
: SELECT SET : CHANGE