Pioneer DRM-7000 Operating Instructions Manual page 46

If a drive's SCSI ID or Termination setting fail to match the displayed information, it is
possible that a cable is cross-connected to the wrong port. Follow the steps below to
reconnect the cables properly.
Disconnect the cables in the following order:
1 – SCSI Interface cable
2 – Changer Interface cable
3 – Power cable
Reverse the order to properly re-connect the drive beginning with the power cable.
If the Changer is unable to read the drive, the host computer fails to automatically configure
the system.
8. Press the Escape button to return to User mode and to close the rear access panel.
scsi ID = 2 TermOFF
dev – ID = 00150360
Press Enter then the Up arrow
B a y # 3 = D r i v e 3
DVDROM DVD-D7563
Press the Enter button
scsi ID = 3 TermOFF
dev – ID = 00000408
Press Enter then the Up arrow
B a y # 4 = D r i v e 4
DVD-R DVD-R7322
Press the Enter button
scsi ID = 4 TermON
dev – ID = 00126B0E
scsi ID = 4 TermON
dev – ID = 00126B0E
Press the Escape button
B a y # 4 = D r i v e 4
DVD-R DVD-R7322
Press the Escape button
- 42 -
DRM-7000
Operating Instructions