Setting The Scsi Id - Pioneer DVR-S201 Operating Instructions Manual

7 Setting the SCSI ID

The SCSI ID is set using the switch on the device's rear
panel.
The computer will recognize each connected SCSI device
by its SCSI ID.
Generally, the SCSI IDs are set as follows: "0" for a hard
disk, "3" for a CD-ROM and "7" for a SCSI interface board
(card). Refer to the operating instructions that accompany
each device to verify that all SCSI devices have different
IDs.
SCSI
ID
Press "+" to increase the number (0, 1, 2,...7) and "–" to
decrease the ID setting (7, 6, 5,...0).
NOTES:
÷ The SCSI ID is preset to "0" at the factory.
÷ To prevent the switch from breaking, do not press "+"
when the SCSI ID selection is set to "7" or "–" when
it is set to "0".
÷ This device will recognize setting the SCSI ID when the
power is turned on.
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug
by tugging the cord and never touch the power cord when
your hands are wet as this could cause a short circuit or
electric shock. Do not place the unit, a piece of furniture, etc.,
on the power cord, or pinch the cord. Never make a knot in the
cord or tie it with other cords. The power cords should be
routed such that they are not likely to be stepped on. A
damaged power cord can cause a fire or give you an electrical
shock. Check the power cord once in a while. When you find
it damaged, ask your nearest PIONEER authorized service
center or your dealer for a replacement.
0
7 SCSI Connector Pin Configuration and Signals
Connector pin numbers and configurations are shown in
the following diagram.
No.25
No.50
Pin No. Signal Pin No.
1 GND 18
2 GND 19
3 GND 20
4 GND 21
5 GND 22
6 GND 23
7 GND 24
8 GND 25
9 GND 26
10 GND 27
11 GND 28
12 OPEN 29
13 OPEN 30
14 OPEN 31
15 GND 32
16 GND 33
17 GND 34
NOTES:
÷ Pin No. 12 to 14, 37 and 39 are not connected
÷ Low active signals are preceded by a "-"
÷ Shield-type connectors are required
CONNECTION
No.1
No.26
Signal Pin No. Signal
GND 35 GND
GND 36 GND
GND 37 OPEN
GND 38 TERM PWR
GND 39 OPEN
GND 40 GND
GND 41 -ATN
GND 42 GND
-DB0 43 -BSY
-DB1 44 -ACK
-DB2 45 -RST
-DB3 46 -MSG
-DB4 47 -SEL
-DB5 48 -C/D
-DB6 49 -REQ
-DB7 50 -I/O
-DBP
9
<DRC1101>
En