To Plug In The Power Cord; To Fold And Unfold - NordicTrack AudioStrider 990 PRO NTEL09109.0 User Manual

HOW TO USE THE ELLiPTiCAL EXERCISER
HOW TO PLUG IN THE POWER CORD
This product must be grounded, if it should mal-
function or break down, grounding provides a path of
least resistance for electric current to reduce the risk
of electric shock, This product is equipped with a cord
having an equipment-grounding conductor and a
grounding plug, Plug the power cord into an appro-
priate outlet that is properly installed and
grounded in accordance with all local codes and
ordinances. This product is for use on a nominal
120-volt circuit, iMPORTANT: The elliptical exer-
ciser is not compatible with GFCl-equipped
outlets.
A temporary
adapter may Outlet Box
be used to
connect the ster
power cord to
a 2-pole
receptacle as
shown at the
right if a prop- Lug
erly grounded Metal Screw
outlet is not
available. The
temporary adapter should be used only until a prop-
erly grounded outlet can be installed by a qualified
electrician.
The green-colored rigid ear, lug, or the like extending
from the adapter must be connected to a permanent
ground such as a properly grounded outlet box cover.
Whenever the adapter is used, it must be held in
place by a metal screw. Some 2-pole receptacle out-
let box covers are not grounded. Contact a
qualified electrician to determine if the outlet box
cover is grounded before using an adapter.
HOW TO FOLD AND UNFOLD THE ELLIPTICAL
EXERCISER
When the elliptical exerciser is not in use, the frame
can be folded out of the way. First, lift the latch under
each pedal arm, and lift the pedal arms off the pedal
arm sleeves.
Latches
Pedal Arms
Handle
Button
Next, raise the pedal arms until they touch the handle-
bars; magnets on the pedal arms will hold the pedal
arms in place. Then, hold the handle and lift the frame
until it locks into a vertical position.
To unfold the elliptical exerciser, first hold the handle,
press the latch button, and lower the frame. Next, pull
the pedal arms away from the handlebars.
Then, lift the latches under the pedal arms, and set
the pedal arms on the pedal arm sleeves. Release the
latches, and make sure that the pedal arms are
securely connected to the pedal arm sleeves.
12