Advertisement
Advertisement
Table of Contents
Related Manuals for Fisher & Paykel WD1001
Summary of Contents for Fisher & Paykel WD1001
- Page 1 Fisher & Paykel Waste Disposal User’s Guide (Models WD1001 and WD2002)
- Page 2 - 2 -...
-
Page 3: Tools Required For Installation
FISHER & PAYKEL WASTE DISPOSAL - INSTALLATION INSTRUCTIONS IMPORTANT Before you start to install your FISHER & PAYKEL Waste disposal please read all of these instructions carefully. This set of instructions is general: local building codes take precedence over the instructions in this guide and your installation must conform to the building codes in your area. - Page 4 UNPACKING YOUR WASTE DISPOSAL Remove the waste disposal from the packing carton, being careful not to misplace any of the pieces. Inside the carton you should find the following: (ILLUSTRATION #2) ILLUSTRATION #2 If any parts are missing contact your dealer before beginning installation. REMOVE OLD DISPOSER OR SINK WASTE REDUCER IF REMOVING AN OLD DISPOSER &...
- Page 5 Then push the waste reducer up through the drain opening. (ILLUSTRATION #6) If the drain opening on your sink is covered with sealant, remove as much of the putty as possible from the rim of the sink drain hole. Unless you have a new home, be sure that the existing trap and drain lines are clear.
-
Page 6: Plumbing Connection
MOUNTING THE DISPOSER Loosen and remove the hinged clamp. (ILLUSTRATION #9). The rubber splash guard should be attached to the waste disposal unit and not to the sink flange. Using two hands, push the disposer upwards so that the inner groove on the splash guard locks on to the sink flange. - Page 7 Slide the waste pipe flange on to the waste pipe. Attach the rubber gasket to the waste pipe so that the thin lip is facing the disposer. (ILLUSTRATION #14) Insert the non-notched end of the waste pipe flange into the slot below the waste outlet on the waste disposer.
-
Page 8: Electrical Connections
ELECTRICAL CONNECTIONS ELECTRICAL CONNECTIONS FOR A FACTORY WIRED DISPOSER: Your FISHER & PAYKEL waste disposal is equipped with a pre-wired power cord, simply plug it in. Electrical connections should be done by a registered electrician. Your FISHER & PAYKEL waste disposal is equipped with a standard 3 pin plug. - Page 9 SAVE THESE INSTRUCTIONS OPERATING INSTRUCTIONS Remove the sink drain plug Turn on the cold water to a medium-high flow, allowing the water to flow into the waste disposer. Turn on your waste disposer. Put all food waste into the disposer while the disposer is operating and the water running. Do not put your hand into the disposer.
-
Page 10: Safety Features
SAFETY FEATURES Your disposer is equipped with an overload protector which prevents the disposer from running should it overload. Overload generally occurs when a foreign object has fallen into the disposer and jammed the impellors, thus preventing the motor from turning. Overload may also occur if you have put too much food waste into the disposer at one time. - Page 11 Fisher & Paykel Appliances Limited FULL TWO YEAR WARRANTY FROM DATE OF PURCHASE FISHER & PAYKEL UNDERTAKES TO Repair or, at its option, replace without cost to the owner either for material or labour any part of the product which is found to be defective within TWO YEARS of the date of purchase. THIS EXPRESS WARRANTY DOES NOT INCLUDE: Service calls to: Correct the installation of the Product.
- Page 12 FISHER & PAYKEL WASTE DISPOSAL INSTALLATION DIMENSIONS MODEL WD1001 WD2002 Measurements in mm Dimensions: Distance from bottom of sink to bottom of disposer Width of disposer Distance from centre of disposer to centre of drain pipe Length from bottom of sink to centre of drain opening...
- Page 13 We want you to be a happy satisfied customer If you need service or assistance, we suggest you follow these steps Before calling for assistance: Check the things you can do yourself. Ensure that the appliance is correctly installed and that you are familiar with it’s normal operation.
Need help?
Do you have a question about the WD1001 and is the answer not in the manual?
Questions and answers