Page 1
Register your product and get support at AJ7010 User manual...
Page 6
Important • Read these instructions. • Heed all warnings. • Follow all instructions. • Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. • Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: • listen to FM/MW radio; • set two alarms; • view time, date, and indoor/outdoor temperature;...
Page 8
Display panel • Show current information. • Select daylight saving time (DST) mode. TIME ZONE • Set time zone. DISPLAY • Activate temperature display setting mode. NATURE SOUND • Activate nature sound setting mode. AC 6V ~ 450mA • Connect power. FM ANT • Improve FM reception. TUNING MODE •...
Main knob • Adjust volume. • Confirm selection. • Adjust settings. • Deactivate nature sound. SNOOZE/BRIGHTNESS • Snooze alarm. • Adjust display brightness. Overview of the outdoor sensor Display panel • Show outdoor temperature and RF channel. LED light • Blink when transmitting data to the main unit. Sensor support °C/°F slide •...
Get started Always follow the instructions in this chapter in sequence. Install battery Caution • Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. • Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. • The battery contains chemical substances, so it should be disposed of properly.
Replace battery of the main unit Note • You can only use AC power as power supply. The pre-installed CR2032 battery can only back up clock and alarm settings. When the low battery icon is displayed, replace the battery as indicated.
Select time zone You can adjust time zone setting according to your location. In standby mode, press TIME ZONE. » The current time zone number blinks on the display. Rotate the main knob to set time zone (-1 to +12 adjustable). Press the knob to confirm. For Europe: Western European Time (WET) Central European Time (CET) +1 (Default) Eastern European Time (EET) Moscow Standard Time (MST) Set clock If the preset time is inaccurate, you can set time and date manually.
• In time and date setting mode, if you press and hold the knob for 3 seconds, the clock radio will save the change and quit the setting mode. Listen to FM/MW radio Tune to radio stations • Position the antenna as far as possible from TV, VCR, or other radiation source.
Rotate the knob slowly to select a frequency. Store radio stations automatically You can store a maximum of 20 FM radio stations and 10 MW radio stations. In tuner mode, press TUNING MODE repeatedly until [AUTO] (auto) blinks. Rotate the main knob slowly. »...
Select a preset radio station In tuner mode, press PRESET, then rotate the main knob to select a preset number. Adjust volume Other features Display indoor/outdoor temperature Adjust temperature display Press DISPLAY. Rotate the knob to select a temperature display mode for the main unit: •...
• To convert between Centigrade (°C) and Fahrenheit (°F) temperature display, adjust °C/°F slide inside the battery compartment of the sensor. • If the main unit fails to receive signal from the sensor, only indoor temperature can be displayed. Improve sensor reception When battery is correctly installed in the sensor, the sensor starts to transmit RF signal to the main unit through Channel 1/2/3.
Press NATURE SOUND. Rotate the knob to select a nature sound. Press the knob to confirm. Rotate the knob to adjust the volume level of the nature sound (0-8). • To deactivate the nature sound, press the knob again. Set alarm timer Set alarm You can set two alarms to ring at different time.
Repeat Step 2-3 to select whether to ring alarm for the whole week, on weekdays (Monday to Friday), or on the weekend (Saturday and Sunday). Repeat steps 2-3 to select an alarm source: radio, buzzer, or a nature sound. Repeat steps 2-3 to set the alarm volume. Activate/deactivate alarm timer Press AL1/AL2 to view alarm settings. Press AL1/AL2 again to activate or deactivate the alarm timer. »...
To deactivate the sleep timer: In sleep timer setting mode, rotate the knob until [OFF] (off) appears, then press the knob. Select DST (daylight saving time) mode For countries with daylight saving time (DST), the clock radio offers you DST option to adjust summer time. In standby mode, press and hold DST for 3 seconds. »...
Specifications Amplifier Rated Output Power 0.6 W RMS Tuner Tuning Range FM: 87.5 - 108 MHz MW: 531-1602 KHz Sensitivity FM: <22 dBu - Mono, 26dB S/N Ratio MW: <92 dBuV/M Search Selectivity FM: <28 dBf MW:<98 dBuV/M Total Harmonic Distortion FM: <3% MW:<5% Signal to Noise Ratio FM: >45 dB MW:>40 dB General information AC Power...
If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/support). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power •...
Page 22
This product complies with the radio interference requirements of the European Community. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
Page 24
Norge Typeskilt finnes på apparatens underside. Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten. For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet.