BASIC OPERATIONS (Continued)
RGB INPUT MODE
* You can also use the buttons
on the display's control
panel to perform these steps.
CONVENIENT FUNCTIONS
Note
• Functions may not be available with some models and some device options.
E-12
1
Press
to select the input mode.
You can select RGB1.
• RGB1: mD-sub
* For selection of the input terminal, see
"SETTING THE INPUT TERMINALS" on
P. E-22.
On-screen information
Press
.
The mode is indicated on the screen for 5 seconds.
Picture Mode
Press
.
This button can be used to switch the picture mode.
In the picture mode, you can switch between the set status and the fine mode.
* For the picture mode settings, see "Picture Mode (P. E-18)".
Picture Memory
Press
.
This button can be used to recall the settings of the picture memories 1 – 8. Each time this button is
pressed, the setting changes as follows.
Memory1 Memory2 Memory3 Memory4 Memory5 Memory6 Memory7
Memory8
* For the picture memory settings, see "Picture Memory (P. E-18)".
RGB1 mode