Show Configuration - Extreme Networks ExtremeWare XOS Command Reference Manual

Configuration and Image Commands

show configuration

show configuration {<module-name>}
Description
Displays a configuration to the terminal.
Syntax Description
module-name Specifies a module.
Default
N/A.
Usage Guidelines
If the output scrolls off the top of the screen, you can use the command to pause the
enable clipaging
display when the output fills the screen. The default for clipaging is enabled.
Extreme Networks recommends using the command to view on the CLI your
show configuration
currently running switch configuration. Do not use a text editor to view or modify your switch
configuration files.
If you specify without any keywords, the switch displays configuration
show configuration
information for each of the switch modules.
You can just display the configuration of a module of interest by using the keyword. For
module-name
example, some of the modules are AAA, ACL, BGP, EDP, FDB, SNMP, and VLAN. Use [TAB]-
completion to see a list.
You must have administrator access to view the output of the command.
save configuration
Depending on the software version running on your switch, the configurations on your switch, and the
type of switch you have, additional or different configuration information may be displayed.
Example
This command shows the current configuration active in the switch:
show configuration
The following is sample output from this command:
# Module devmgr configuration.
#
configure snmp sysName "Engineering"
configure snmp sysContact "support@extremenetworks.com, +1 888 257 3000"
#
1638
ExtremeWare XOS 11.3 Command Reference