Install Battery Cables - Troy-Bilt 12090 Owner's Manual

Section2: Assembly
STEP 4: Install the
Battery Cables
NOTE: The cable terminals should be
toward the rear (keyswitch side) of the
battery posts.
1. Use a 5/8" long screw and 1/4-20 hex
nut to connect the positive (+) battery
cable (J, Figure 2-19) to the positive
(marked +) battery post (K). Make sure
that this is the cable on the left side, with
one end attachedto the solenoid (Q).
2. Slide the black rubber boot (P) com-
pletely over the battery post and cable
connector.
3. Use a 5/8" long screw and 1/4-20 hex
nut to connect the negative (-) battery
cable (L) to the negative (marked -)
battery post (M) and secure with screw
(R) and nut (S),
4. Slide the black rubber boot (T) com-
pletely over the battery post and cable
connector.
5. Make sure that the lower end of the
vent tube shield (U) is positioned in front
of the wheel shaft axle. Move it there if
necessary.
Assembly is complete for electric start
tillers. SeeSection 3, Controlsfor
information on tiller controls.
N
Figure 2.19: Battery cable assembly.
12