Table of Contents
Advertisement
(_
Trademark
_l_
Please do not return unit to retailer.
Por favor, no devuelva
el aparato al lugar de compra.
Veuillez ne pas retourner
I'outil au detaillant.
•
1-800-554-6723
www.weedeater.com
&
Instruction
Manual
Manual de Instrucciones
Manuel d'lnstructions
H
RTE115C
H
U
WARNING:
Read and follow all Safety Rules and Operating
Instructions before
using this product. Read instructions
carefully before assembling.
Failure to do so can result in serious injury.
ADVERTENClA"
Lea el manual del operador y siga todas las advertencias
e instruc-
ciones de seguridad. Antes de ensamblar el producto lea cuidado-
samente el instructivo. El no hacerlo puede resultar en lesiones gra-
ves.
AVERTISSEMENT:
Veuillez lire le manuel de I'utilisateur
et bien respecter tousles
avertissements
et toutes les instructions
de s6curit&
Bien lire les
instructions avant d'assembler
I'outil. Tout d6faut de le faire pourrait
entrainer
des blessures
graves.
WEED EATER
WEED EATER
1030 Stevens
Creek Road
5855 Terry Fox Way
Augusta,
GA 30907
Mississauga,
Ontario
L5V 3E4
545117538
8/8/06
Advertisement
Table of Contents
Related Manuals for Weed Eater RTE115C
Summary of Contents for Weed Eater RTE115C
- Page 1 Bien lire les instructions avant d'assembler I'outil. Tout d6faut de le faire pourrait entrainer des blessures graves. WEED EATER WEED EATER 1030 Stevens Creek Road 5855 Terry Fox Way Augusta, GA 30907 Mississauga, Ontario...
- Page 2 clothing with loosely hanging ties, straps, WARNING: When using electric gar- tassels, etc. They can be caught in moving dening appliances, basic safety precautions parts. • Being fully covered also helps protect you must always be followed to reduce the risk of from debris pieces...
- Page 3 • Use only WEED EATER replacement parts electrical insulation failure. and accessories as recommended. CUTTING SAFETY ,_ILWARNING: All electrical repairs •...
- Page 4 m_WARNINu: d=:BWARNINu: If received assembled, upper lower review all assembly steps to ensure your unit tubes must be snapped together, remain per- is properly assembled and all fasteners manently assembled together and the locking secure. sleeve assembly must be fully tightened fore and during use to avoid serious injury to TUBE...
- Page 5 Shield Push shield toward motor housing until Opening rear locking tabs snap into rear notches• Front An audible snap must be heard. Ensure Locking the cutting head remains free to rotate and the line is not caught between shield and the motor housing. Cutting Head Shield Motor Housing...
- Page 6 OPERATING INSTRUCTIONS Upon unit start up, the line will advance auto- matically to the correct cutting path length. Use only a voltage supply as specified Always keep the shield in place when the tool your unit. is being operated. SELECT EXTENSION CORD _IkWARNING:...
- Page 7 SWEEPING The fanning action of the rotating line can be II kll used for a quick and easy clean up. Keep the line parallel to and above the surfaces being swept and move the tool from side to side. MOWING Your trimmer is ideal for mowing...
- Page 8 REFILLING THE SPOOL WITH LINE Insert one end of line into center cavity of empty spool. Ensure line will feed into _ILWARNING: spool in the direction shown on the spool only 0.065 inch (counterclockwise). (1.65 mm) diameter round line. Other sizes Continue feeding line into spool, leaving...
- Page 9 (2) years from the THERE ARE NO OTHER EXPRESS WARRANTIES EXCEPT THOSE original date of purchase. If your WEED EATER brand electric or cordless PRESSLY STIPULATED HEREIN. product should fail within the limited warranty SOME STATES DO NOT...
Need help?
Do you have a question about the RTE115C and is the answer not in the manual?
Questions and answers