Table of Contents
Advertisement
Things
to Consider
Before
You Connect
Protect
Against
Power Surges
Connect all components
before you plug any of their power cords into the wall outlet,
]urn off the TV and/or component
before you connect or disconnect
any cables,
Make sure all antennas and cables are properly grounded,
Refer to the Important
Safety Instructions
packed separately.
Protect
Components
from
Overheating
Don't block ventilation
holes on any of the components.
Arrange the components
so that air can
circulate flee[y.
Don't stack components.
If you place components
in a stand, make sure you allow adequate ventilation,
If you connect an audio receiver or amplifier,
place it on the top shelf so the heated air from it won't
flow around other components.
Position
Cables
Properly
to Avoid
Audio
Interference
Insert each cable firmly into the designated jack,
If you place components
above the TV, route all cables down the side of the back of the TV instead
of straight down the middle of the TV.
If your antenna uses 300-ohm
twin lead cables, do not coil the cables, Also, keep the twin lead
cables away from audio/video
cables.
Important
Stand
and Base Safety
Information
Choose the location for your TV carefully, Place the TV on a stand or base that is of adequate size and
strength to prevent the TV from being accidentafly
tipped over, pushed off, or pulled off. This could
cause personal injury and/or damage the TV. Refer to the important
Safety Instructions
packed
separately.
Use Indirect
Light
Don't place the TV where sunlight
or room lighting
will be directed toward the screen. Use soft or
indirect
lighting,
Cables Needed
to Connect
Components
to Your TV
The pictures below show the cables needed for the connections
represented
in this book.
Coaxial cable
S Video cable
Audio/Video cables
Chapter 1
Graphics contained
within
this publication
are for representation
only
3
Advertisement
Table of Contents
