Install Channels; Select Your Menu Language; Set Your Location To Home; Automatically Install Channels - Philips 47PFL3704D User Manual

7 Install channels
The first time you setup yourT_, you are prompted to select a menu
language and to installq=V and digital radio channels (if available).This
chapter provides instructions on how to reinstall and fine-tune channels.
2
3
Press OK to start the installation.
• If you run [Autoprogram] on locked channels, you must to
enter your PIN code.
• If you have forgotten your PIN, reset it (see 'Set or change
your PIN' on page 16).
Select [Cable] or [Antenna] and press OK.
..... i!i
?##########
Select your menu language
t Press MENU on the remote control and select [installation] >
[Language].
TV menu
Installation
Language
_- Select a language and press OK to confirm your choice.
3 Press 4 to return to the [installation] menu.
Set your
location to home
You can set the location ofyourTV to home or retail store. Choose home
so that you can change the predefined settings for picture and sound.
t Press MENU on the remote control and select [Installation] >
[Preferences] > [Location].
2
Select [Home] and press OK to confirm your choice.
3 Press 4 to return to the [Installation] menu.
Automatically install
channels
Before you install channels, ensure that you are registered with your
cableTV provider and that your equipment is correctly connected.
t Press MENU on the remote control and select [Installation] >
[Channels] > [Autoprogram] > [Start now].
Installation
Channels
Autoprogram
Autoprogram
TV installation
4
• When [Antenna] is selected, the TV detects antenna signals. It
searches for NTSC and ATSC channels available in your area.
• When [Cable] is selected, theTV detects signals supplied
by cable. It searches for NTSC, ATSC, and QAM modulated
channels available in your area.
• When complete, this message appears [Channel search
completed.].
Follow the on-screen instructions to complete the installation.
Optimize the signal quality from your
antenna
You can optimize your signal quality by tuning in ATSC channels with
weal< signals, and adjusting the antenna.
t Press MENU on the remote control and select [Installation] >
[Channels] > [installation mode] mode.
2 Select [Antenna] and press 41to confirm your choice.
3 Press A and _ to enter [Weak channel installation].
4
Highlight a channel from the list ofq=V channels and press the green
color button on the remote control.
L_ The signal strength for the channel is displayed.
S Adjust your antenna to maximize the signal strength.
6 Press MENU to exit.
EN 23