Advertisement
OWNER'S MANUAL
Sears Peyton 4pc seating Set
* Fixed Arm Rocker
Product Code: D71 M80900
UPC Code: 7-22938-07945-2
Date of Purchase: __ / __ / __
If you have any problems with this product, DO NOT RETURN IT TO THE STORE.
CALL OUR CUSTOMER SERVICE HOT-LINE AT
866-391-4868
8am-5pm (EST), Monday-Friday.
View the expanded assortment of outdoor living product on-line at
WWW.lazboyoutdoor.com
and
WWW.sears.com
Page 1 of 6
Advertisement
Table of Contents
Related Manuals for LAZBOY D71 M80900
Summary of Contents for LAZBOY D71 M80900
- Page 1 OWNER’S MANUAL Sears Peyton 4pc seating Set * Fixed Arm Rocker Product Code: D71 M80900 UPC Code: 7-22938-07945-2 Date of Purchase: __ / __ / __ If you have any problems with this product, DO NOT RETURN IT TO THE STORE. CALL OUR CUSTOMER SERVICE HOT-LINE AT 866-391-4868 8am-5pm (EST), Monday-Friday.
- Page 2 W A R R A N T Y This warranty is a limited warranty, and applies to the original purchase only. Proof of purchase is required. This is a residential warranty and does not apply to commercial use. This collection carries a 5 year limited warranty and is valid from original date of purchase to the original owner (proof of purchase required): NOTE: Glass breakage is not a warranted item.
-
Page 3: Parts List
CAUTION: Read all the instruction before assembly. Failure to do so may result in faulty assembly and potential injury! Assemble the item on a soft, non-abrasive surface such as a carpet or cardboard to avoid damaging the item. Seek assistance to assemble bulky or heavy items. After final alignment, make sure all bolts, nuts and nut covers are securely tightened. - Page 4 M8 Spring Washer M8 Nut Bolt Cap (M6) Bolt Cap (M8) Steel Plate Hex Wrench Seat Cushion Back Cushion Lumbar Pillow Assembly Steps: Step1: Attach right arm (B) to chair back (A) with M6x45mm hex head bolt (F), M6 washer (H). Repeat the same procedure on the left arm (C).
- Page 5 Step2: Attach seat (D) to right arm (B) with M6x45mm hex head bolt (F), M6 washer (H). Repeat the same procedure on the left arm (C). Tighten loosely at this step. (See Figure 2) Figure 2 Step3: Place the seat frame and back frame on the chair base (E), make sure the holes in the fireboard are completely aligned with the holes in the “U”...
- Page 6 Figure 3 Step4: Tighten all bolts and nuts with hex wrenches (N). Do not over tighten. Cover all bolts (F) with bolts cap (K), bolts (G) with bolts cap (L). Step5: Place seat cushion (O), back cushion (P) and lumbar pillow (Q) in chair as show Figure 4. Check and be sure the chair is assembled tightly and stable before you use.
Need help?
Do you have a question about the D71 M80900 and is the answer not in the manual?
Questions and answers