Dell OptiPlex HUB Setup Manual page 2

5 Connect one AC pass-through power cord to hub and
Host PC. Connect other AC pass-through power cord
to hub and monitor.
NOTE: Do not connect AC pass-through connectors
to other devices without checking the Product
Information Guide
8 Turn power switch on. Ensure green "Status" LED
is illuminated
Information in this document is subject to change without notice.
© 2006 Dell Inc. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell is strictly forbidden.
Dell and the DELL logo are trademarks of Dell Inc. Dell disclaims proprietary interest in the marks and names of others.
February 2006
6 Connect USB cable to hub and Host PC
(Windows XP)
(Windows 2000)
9 Allow Windows to install drivers for devices. Ensure
green "Host" and green "Port" LEDs are illuminated.
Amber "Port" LEDs indicate over-current
2 - Cables not included. Peripherals sold separately.
2
7 Connect peripheral cables to peripherals and then
hub when hot-plugging. NOTE: This order must be
observed or damage may result to peripherals
and/or hub
(b)
(a)
10 If Integrator is used, slide Integrator tray in (a) and
replace cover (b)
Waste Electrical and Electronic Equipment (WEEE) Directive
In the European Union, this label indicates that this product should
not be disposed of with household waste. It should be deposited at an
appropriate facility to enable recovery and recycling.
For information on how to recycle this product responsibly in your
country, please visit: www.euro.dell.com/recycling. Printed in China