Installation Instructions; Worksurface Care - Whirlpool MW29000TB0 Use And Care Manual

INSTALLATION INSTRUCTIONS
1. Remove the rubber mat(s) from the top of the worksurface and
set aside.
Excessive Weight Hazard
Use two or more people to move and uninstall washer.
Failure to do so can result in back or other injury.
Excessive Weight Hazard
Use two or more people to move and uninstall dryer.
Failure to do so can result in back or other injury.
2,
3.
Check the spacing between your washer and dryer. If
necessary, move your washer or dryer so that there is a space
of approximately 1" (2.5 cm) between them.
Check that the washer and dryer are level front to back and
side to side and the difference in height is no more than 3/8"
(0,95 cm). Place a level on both the washer and dryer to
determine any difference in height. If necessary, adjust the
washer or dryer feet.
1 "
(2.5 cm)
4. Place the worksurface on top of the washer and dryer. Holding
the front edge up, hook the back edge over the back of the
washer and dryer. Center it left to right so that the alignment
pads fit in the space between the washer and dryer.
5. Check that the top of the washer and the bottom of the rubber
mat(s) are clean and set in place on top of the worksurface.
6. Dispose of/recycle all packaging materials.
WORKSURFACE CARE
The worksurface can be used for sorting, treating and folding
laundry and for storing various laundry products.
IMPORTANT: The worksurface is not intended for ironing. Using
an iron on the worksurface could cause it to become discolored.
Cleaning the Worksurface
• Use a soft damp cloth or sponge to wipe up any spills.
Occasionally wipe the worksurface to keep it looking new,
• Use mild soap and water or a household cleaner and a soft
brush on the worksurface; do not use abrasive products.
NOTE: Refer to your model's Use and Care Guide for tools
required and leveling instructions.