Stopping Engine; Additional Information; Starting A Flooded Engine; What To Do Just In Case - Mantis 7222 Owner's Manual

Tiller/cultivator
Table of Contents

Advertisement

STARTING (co.ti.ued)
Additional
Information
How
to Stop
the Engine
Simply
push
the oh
' stop/start"
switch
to
'O" (Picture
3). This
will stop the engine
instantly.
If it should
Picture 3
ever fail to do so, just
pull out the choke
button.
The engine
will stop at once.
About
the Choke
The choke
controls
the amount
of
air drawn
into the engine.
Your tiller
will run only if the choke is open --
that is, if the choke is pushed
in.
¥HAT
TO
A Special
Feature
(with
the idle set properly
and the en_ne
running)
Even when the engine
is running,
the tines won't
turn unless
you press
the throttle
lock out button
and
squeeze
the throttle
lever on the
handlebars.
And, when you release
the
throttle
lever, the tines will stop.
A Tip for Extending
Your Engine's
Life
After you start the engine,
let your
tiller warm up for two to three minutes
betore you use it. Then, before you put
DO JUST
IN CASE
your tiller away; let it idle for a minute to
give the engine a chance to cool down.
If you follow the normal
starting procedure, you should
have no problem starting your
tiller. But, just in case you do
have problems, here's what to do.
Make sure the oh switch is on I
%tart." You'd be surprised how
many people forget to push the
switch into the 'T' position.
If the switch was on 'o" when
you pulled the cord, you may have
flooded the engine.
Picture
1
Picture
2
Picture
3
• First, examine
the spark
plug. Use the
special wrench
that comes
with our
optional
MANTIS Handy
Item Kit
(item #8444)
or a 3/4 inch spark
plug
wrench.
(Picture
1)
•Remove the cap over the spark plug.
•Unscrew the spark plug. (Picture 2)
IMPORTANT
NOTE:
To avoid possible
damage to the
threads,
do not try" to remove
the plug
from a hot alminum
Wlinder
head.
Starting
a Flooded
Engine
1. if the end of the spark plug is wet,
the engine
may be flooded.
Make
sure
the switch
is in the "0" position,
8
disconnect spark
plug wire and
remove plug. Use a paper towd or a
dean rag to dry, the spark plug, then,
with the spark plug out of the engine,
pull the starter
cord several times.
Next, replace the spark plug.
Use the wrench to tighten it and replace
the cap. Next, put the switch in the "|"
position and pull the choke button out.
Pull the starter cord three or four times
until the engine coughs or sputters.
Open the choke (push the choke button
in) and pull the cord a few times, the
engine should start and run.
2, If the end of the spark plug is dry;
check to see if the fuel liine is blocke&
First loosen the fuel cap to relieve the
pressure in the tank. The fuel line runs
from the fuel tank to the carburetor,
Pull it off at the carburetor end. Fuel
should drip slowly from the line Wipe
off any excess or spilled fuel.
If fiaeI does not drip from t/he line,
flow of fuel to the engine. Just
If fuel drips too freely, the line may be
disconnected from the fuel filter. >au'll
find the t;ael filter inside the fuel tank.
Just re-attach the line to the filter, and put
the filter back in the rank. Then follow
the normal starting procedure.
Here's
Another
Way
to
Start
your
MA_NTIS
Tiller
if you follow the steps above and
your engine
still won't
start, try this:
I Push
the switch
to 'l".
2. Push in the choke button to open
the choke,
3. Press the plastic bubble a few times.
4_ Give the starter
cord a few short,
quick pulls_ The engine
should
start
and
run_
5. If the engine
does not start, then
pull out the choke
button
to cIose the
choke.
Pull the starter
cord four to five
times. The engine
should
sputter
or
cough.
6. Alter the engine
sputters,
push the
choke
button
in. Then pull the starter
cord
The engine
should
start and run.
7_ If the engine
still does not start,
repeat steps 2 through
6.
8. If the engine
still does not start,
call your local
authorized
I_NTIS
dealer.
IMPORTANT
NOTE:
Never u_ starting
tluids° Starting
fluids
will eau_
permanent
en_e
damage.
Using them will void the warranty.
IMPORTANT
NOTE:
Before
yon use your MANTIS
Tiller,
read
the Safety
Rules
& Warnings
on
pages
3-4.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 7222 and is the answer not in the manual?

Questions and answers

Chuck
February 4, 2025

I have the 7222M and it's leaking fluid either in the axle area or transmission. Please advise

Gary Roberts
February 25, 2025

what kind of fuel does the Mantis tiller use?

2 comments:
Mr. Anderson
February 25, 2025

The Mantis tiller model 7222 is a 2-cycle engine, which typically requires a mixture of gasoline and 2-cycle engine oil. However, the exact fuel mixture ratio is not specified in the provided context.

This answer is automatically generated

Karen
April 29, 2025

@Gary Roberts: Per the owner's manual: Fuel your MANTIS Tiller with a fuel mixture of gasoline and lubricating oil. Use a mixture of 50 parts unleaded regular gasoline and one part two-stroke MANTIS oil (50:1.) Use branded 89 octancd (R÷M+2) unleaded gasoline or gasobol(maxmmm 10% ethyl alcohol.

This manual is also suitable for:

7225

Table of Contents

Save PDF