Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
INSTRUCTIONS
Excessive
Weight Hazard
Use two or more people to move and install side
burner.
Failure to do so can result in back or other injury.
3. Remove the top nuts (4) from the tank tray assembly and lift
the tank tray off of the mounting brackets.
Unpack side burner. Remove all packaging materials and
remove side burner from carton.
Place side burner into outdoor enclosure, but leave enough
room in back to connect to gas supply and electrical single
prong plug-in.
ss
,,_
.......
1. Position the tank tray for 201b LP gas fuel tank in the island
cabinet.
4=
A. Top nut
B. Tank tray
C. Bottom nut
D. Bolt
E. Mounting bracket
Install the tank tray mounting brackets to the base or floor of
the island using the proper size and type of mounting
hardware (not supplied). Tighten mounting hardware.
B
/
3"
(7.6 crn)
centerline of
tank tray
21/4"
(5.7 crn)
20%"
18%"
Dimension A
Dimension B
Front to back burner
83/32"(20.6 cm)
163/16"(41.1 cm)
Side by side burner
12%d' (31.9 cm)
25V8" (63.8 cm)
2. Square the tank tray mounting brackets and mark the
mounting hole locations in the island base.
A. Screw (Use proper screw for island floor material.)
B. Lock washer
C. Flat washer
5. Pre-adjust each of the bottom nuts on the mounting brackets
to 3" (7.6 cm) from the base of the island to the top of the
nuts.
6. Remount the tank tray back onto the mounting brackets.
Replace the 4 top nuts but do not tighten.
A 0
B
C
A. 20 Ib LP gas fuel tank
B. Tank tray for 20 Ib gas fuel tank
C. Top nut (do not tighten)
D. Mounting bracket
13
Advertisement
Table of Contents
