Secure Drain Hose - Kenmore 11098762790 Owner's Manual And Installation Instructions

F. SECURE CABLE BRACKET
STEP 1. Cut the plastic strap securing
the cable wire bracket to the power
supply cord. Do not cut cable. Remove
the power supply cord from the bracket.
Discard plastic strap.
G. SECURE DRAIN HOSE
Securing the drain hose properly will
protect your floors from damage due
to water leakage.
STEP 1. Move laundry center to its final
location.
STEP 2. Locate the remaining piece
of shipping strap (not the end with
the three cotter pins) from STEP 3 of
"REMOVE SHIPPING STRAR" Use
it to wrap the drain hose together with
the laundry tub or standpipe. Push
fastener into the nearest hole in the
shipping strap.
STEP 2. Mark the hole locations on the
wall where the bracket wilt be installed.
Prepare mounting holes suitable for your
wall construction.
STEP 3. Attach the cable wire bracket
to a board and mount on the wall. Check
that bracket is secure. For some instal-
lations it may be easier to make the gas
and exhaust vent connections before
attaching cable bracket to wall.
NOTE: Screws to attach the cable bracket
have not been provided because of the
variation of walt surfaces. Select the
correct type of fasteners for your type
of wall construction.
If the water faucets and drain standpipe
are recessed, put hooked end of drain
hose in standpipe. Tightly wrap the
shipping strap around the drain hose
and water inlet hoses (not the handles
or stems). Push fastener into the
nearest hole in the shipping strap.
x\ i i-
23