Install Custom Overlay Frame - KitchenAid KBCO24LSBX03 Use & Care Manual

• Dispose of/recycle allpackaging materials.
When
Moving Your Beverage Center:
Your beverage center is heavy. When moving the appliance
for service, be sure to protect the floor. Always pull the
appliance straight out when moving it. Do not wiggle or
"walk" the appliance when trying to move it, as floor
damage could occur.
3=
Open the door. Lift the front of the door up, pulling straight
out to remove as shown.
Clean Before Using
After you remove all of the packaging materials, clean the inside
of your beverage center before using it. See the cleaning
instructions in "Beverage Center Care."
IM PO RTANT:
• Create custom overlay frame according to the specifications
in the "Custom Overlay Frame" section.
• KitchenAid is not responsible for the removal or addition of
decorative frames that would prevent the appliance from
being serviced.
Remove the Door
IMPORTANT: Do not remove the grease from the washer, top
spacer or top hinge pin. Be sure to set aside the top hinge, top
spacer and washer for later use.
1. Using a Phillips screwdriver, remove the three screws from
the top hinge. Remove the top hinge.
A
::::::::::::::::::::: A
_ Ii ii B ................ C
A. Screws (3)
B. Top hinge
C. Washer
D. Top spacer
E, Door
2. Remove the three screws from the top spacer. Remove the
top spacer and washer.
Attach the Overlay Frame
NOTE: If the overlay hooks are not installed, see "Custom
Overlay Frame" for overlay hook locations.
1. Position the overlay frame 1/2"(1.27 cm) higher than the door.
Be sure to position the overlay hooks to the pilot holes.
2. Insert the overlay hooks into the top of the holes in the door.
Push against the overlay frame to force the overlay hooks
deeper into the door. Pull the overlay frame straight down to
secure the overlay hooks to the door.
3. Using a Phillips screwdriver, attach the overlay plates to the
bottom of the overlay frame and door as shown.
B C D
A. Overlay frame
B. Door
C. Overlay plates (2)
D. Round-head screws (8)