Operating The Cooking Zones; Preheat Recommendations; Led Messages Or Light Indicators Displayed By Cooking Zone Controls - Electrolux EW36IC60LB1 Use & Care Manual

Settin Surface Controls
Setting "power boost" feature
Your induction cooktop is equipped with a Power
Boost feature on each cooking zone. The Power Boost
feature is used to bring large quantities of water or food
to cooking temperature at the fastest speed possible.
The Power Boost feature will give you up to 139%
power output for a maximum of 10 minutes.
To Turn ON the Power Boost Feature:
Turn on the cooking zone you want to set to
Power Boost then press the "÷" key pad and the
Power Boost will be shown in the display as well as
the HI indicator (figure 1).
Figure 1
To set the Power
Boost, press +
when the zone is
first turned on.
Preheat recommendations
When preheating a pan on the cooktop always watch
carefully. Whenever using the cooktop the user should
always pay attention to any items cooking and remain
attentive until the cooking process is complete.
Keep in mind that induction may decrease the amount
of time required to preheat the desired pan.
LED messages or light
indicators displayed by
cooking zone controls
POWER LEVEL SETTINGS - The Cooking Zones
have separate Power Level displays. Once active,
the Cooking Zones will provide 26 Power Levels
to choose from. These include Lo (Fig. 1), 2, 9, if,
5, 5, ?, B, Stand HI; as well as precise .2 increment
Cooking Zone Power Levels between L o and 9 (Fig.
2); and half-increment power levels between 9 and
St.S(Fig. 3). The highest setting of "Power Boost"
(Fig. 4) provides up to 139% power for 10 minutes
or 14 minutes for specific cooking zones.
RESIDUAL HEAT - Once any Cooking Zone has
been used and the cooktop surface temperature on
any of the Cooking Zones is still HOT, hot surface
(See Fig. 5) will appear in the display for the affected
Cooking Zone. The hot surface will continue to
display even if the Cooking Zone has been turned
OFF as long as the temperature is still too HOT.
KEEP WARM =Use the WARM key pad to activate the
Warm setting for any of the Cooking Zones. The ON/
OFF key pad for the desired Cooking Zone must be
activated first, then touch the Cooking Zone WARM
key pad area once to set. L,I ( warm) should appear in
the corresponding Cooking Zone display (See Fig. 6).
You can also press the "-" pad until U appears.
PAN DETECTION -All Cooking Zones will provide a
Pan Detection message. If a Cooking Zone is turned
ON and no pan is detected, or the pan has been
moved or is not centered correctly, or is not made of
magnetic material, the affected Cooking Zone display
will rotate the LEDs surrounding the digital display
and the Cooking Zone will not heat. The LEDs will
continue to rotate until either a pan is detected or until
the zone is turned off either by pressing the ON/OFF
key pad or 3 minutes after the no pan detection has
commenced.
Fig. 1 Fig. 2 Fig. 3
Fig. 4 Fig. 5 Fig. 6