Kenmore 272.98201.490 Owner's Manual page 8

NOTE: The following assemblies should be done
with Cabinet upright.
Step 9. Attach Hinges to Leaf Supports with
(4) #8x518" Flathead screws each,
tap Magnet with hammer, (as shown
in FIG. 8A). Attach Bronze Strikes to
outside of Left and Right sides with #5xl/2"
Flathead Screw as in FIG. 8. Attach Self
Sticking Rubber Tab to the top outside edge of
each Leaf Support, as in FIG. 8A. Attach Leaf
Support to right and Left Sides with (8) #8x5/8"
Flathead Screws. Wings should fold to back of
cabinet (see FIG. 8).
#8x5/8" Round
Flathead Magnet
Screw_oo_ - -
FIG. 8A
Self Sticking
Rubber Tab
CAUTION: When applying the SELF STICKING RUBBER TAB,
CAREFULLY REMOVE THE WHITE PAPER BACKING ONLY.
Step 10. Attach the Front Support to the cabinet Partition
• using (2) #5xl/2" Flathead Screws (as shown in
FIG. 9). Tension can be adjusted on the Front
Support by tightening the adjustment screw (as
shown in FIG. 9A).
FIG. 9
Partition
#5x1/2" [1_--__ ._ _._
Flathead Screws_\- _
Front Support -_
FIG. 8
Tension
Adjustment
FIG. 9A
rt
Step 11. Turn the Top over (with Platform hanging down)
and guide the Connecting Bolts into the holes on
the top edge
of the Sides and Partition. Open
leaves to rest on Leaf Supports. Reach through
the opening in the Top and turn Cams to the
Locked position
(as shown in FIG. 10). Now reach
into the Compartment and Lock the Cams in the
same manner.
Page 7
Top/Base Assembly
98200-7
98201-7