Page 2
SAFETY RULES Safe Operation Practices for Ride=On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. Do not operate machine without the entire grass catcher, WARNING: in order to prevent ac- discharge guard, or other safety devices in place and...
Page 3
SAFETY RULES Safe Operation Practices for Ride=On Mowers ill. CHILDREN GENERAL SERVICE • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to •...
Page 4
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBiLiTIES Gasoline Capacity 2.5 Gallons • Read and observe the safety rules, and type: Unleaded Regular • Follow a regular schedule in maintaining, caring for Oil Type (API-SG-SL): SAE 30 (above 32°F) and using your tractor, SAE 5W-30 (below 32°F) •...
Page 5
UNASSEMBLED PARTS Slope Sheet (2) Keys ASSEMBLY Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping puposes. When right or left hand is mentioned in this manual, it means ADJUST SEAT (See Fig.
Page 6
ASSEMBLY • Release parking brake by depressing brake pedal. V'CHECKLIST • Place freewheel control in disengaged position to dis- BEFORE YOU OPERATE YOUR NEW TRACTOR, WE engage transmission (See "TO TRANSPORT" in the WISH TO ASS URE THAT YOU RECEIVE THE BES T PER- Operation section of this manual), FORMANCEAND SATISFACTION FROM THIS QUALITY...
Page 7
OPERATION These symbols may appear on your tractor or in literature supplied with the product, Learn and understand their mean- ing, I",I@ REVERSE NEUTRAL HIGH CHOKE FAST SLOW IGNITION SWITCH I-lII4I 45 (®) .¢, ENGINE OFF REVERSE ENGINE ON ENGINE START PARKING BRAKE MOWER...
Page 8
OPERATION KNOW YOUR TRACTOR READ THiS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. 03026 FIG. 3 Our tractors conform to the applicable safety standards of the American National Standards Institute.
Page 9
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask worn over spectacles.
Page 10
OPERATION TO ADJUST GAUGE WHEELS (See Fig. 9) Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions, NOTE: Adjust gauge wheels with tractor on a flat level surface.
Page 11
OPERATION Transmission Engaged REVERSE OPERATION SYSTEM (ROS) Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position, _WARNING: Backing up with the attachment clutch en-...
Page 12
OPERATION ADD GASOLINE COLD WEATHER STARTING (50 ° F and below) • Fill fuel tank to bottom of filler neck. Do not overfill. Use • When engine starts, slowly push choke control in until fresh, clean, regular unleaded gasoline with a minimum of the engine begins to run smoothly.
Page 13
OPERATION • Shut- off engine and set parking brake. • Engage transmission by placing freewheel control in engaged position (See "TO TRANSPORT" in this sec- tion of manual). • Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed, Disengage parking brake.
Page 14
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH SEASON STORAGE SCHEDULE HOURS HOURS HOURS HOURS v" Check Brake Operation v" Check Tire Pressure Check Operator Presence & ROS Systems v" v" A Check for Loose Fasteners C Check/Replace Mower Blades 1,,"...
Page 15
MAINTENANCE TRACTOR BLADE CARE Always observe safety rules when performing any main- For best results mower blades must be sharp, Replace tenance. worn, bent or damaged blades. BRAKE OPERATION CAUTION: Use only a replacement If tractor requires more than five (5) feet to stop at highest blade approved by the manufacturer of speed in highest gear on a level, dry concrete or paved your tractor, Using a blade not approved...
Page 16
MAINTENANCE TO CHANGE ENGINE OIL (See Figs. 14 and 15) • Coat terminals with grease or petroleum jelly. • Reinstall battery (See "REPLACING BATTERY" in Determine temperature range expected before oil change. the SERVICE AND ADJUSTMENTS section of this All oil must meet API service classification SG-SL. manual).
Page 17
MAINTENANCE MUFFLER CLAMP inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or dam- age. SPARK PLUGS FiG. 16 Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever CLEANING occurs first.
Page 18
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in "DISENGAGED" position. • Turn ignition key to "STOP" and remove key. •...
Page 19
SERVICE AND ADJUSTMENTS • ATTACH FRONT U NK (E) - Work from left side of trac- tor, Insert rod end of link assembly through front hole in tractor front suspension bracket (F), • Insert end of link (E) into hole in front mower bracket and secure with washer and retainer spring (J), FIG.
Page 20
SERVICE AND ADJUSTMENTS TO LEVEL MOWER • If adjustment is necessary, see step in Visual Adjust- ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the sides are equal.
Page 21
SERVICE AND ADJUSTMENTS TO REPLACE MOWER DRIVE BELT • Slide belt toward rear of tractor, off the steering plate (F) and remove from tractor. (See Fig. 26) BELT INSTALLATION - MOWER DRIVE BELT REMOVAL • Install new belt from tractor rear to front, over the steer- •...
Page 22
SERVICE AND ADJUSTMENTS TO START ENGINE WITH A WEAK BATTERY TO CHECK BRAKE (See Fig. 29) if tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced. erate explosive gases.
Page 23
SERVICE AND ADJUSTMENTS TO REPLACE BATTERY TO REMOVE HOOD AND GREL ASSEMBLY (See Fig. 30) (See Fig. 31) WARNING: Do not short battery terminals • Raise hood. by allowing a wrench or any other object to contact both terminals at the same time, •...
Page 24
STORAGE ENGINE Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. FUEL SYSTEM IMPORTANT: IT IS IMPORTANTTO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUELSYSTEM PARTS SUCH...
Page 25
TROUBLES OOTI G POINTS PROBLEM CAUSE CORRECTION Will not start Out of fuel. Fill fuel tank. Engine not "CHOKED" properly. See "TO START ENGINE" in Operation section. Engine flooded. Wait several minutes before attempting to start. Bad spark plug. Replace spark plug. Weak or dead battery.
Page 26
TROUBLESHOOTI POINTS PROBLEM CAUSE CORRECTION Engine dies when Reverse operation system Turn ignition key to tractor is shifted (ROS) is not 1'ON"while ROS "ON" position. into reverse mower or other attachment See Operation section. is engaged. Engine continues to run Faulty operator-safety presence control system.
Page 27
TRACTOR ==MODEL NUMBER 917.287540, PRODUCT NO. YTH2246 SCHEMATIC BATTERY SOLENOID STARTER FUSE BLACK ELECTRIC CLUTCH WHITE WHITE WHITE RE[) Y--If =_PEDA_L UP_,).J REVERSE SWITCH PTO SWITCH (NOT IN REVERSE) m (DISENGAGED) BLACK ..BLACK BLACK BLACK GRAY BLACK JUNCTION CONNECTOR SHORTING CONNECTOR CHASSIS...
Page 28
TRACTOR = = MODEL NUMBER 917.287540, PRODUCT YTH2246 ELECTRICAL 400449...
Page 32
TRACTOR MODEL NUMBER DRIVE 917.287540, PRODucT YTH2246 drive-te_< 43.Husq TuffTorq...
Page 33
TRACTOR MODEL NUMBER 917.287540, PRODUCT YTH2246 DRIVE PART PART DESCRIPTION DESCRIPTION Bolt 532 40 53-84 Transaxle, TUFFTORQ K46BT 872 11 06-22 532 13 70-57 (See Transaxle breakdown) Spacer Axle 532 12 35-83 Key Square 532 40 31-18 Handle Parking Brake Bolt 872 11 06-20 819 13 13-16 Washer 13/32 x 13/16 x 16 Ga.
Page 34
TRACTOR = = MODEL NUMBER 917.287540, PRODUCT YTH2246 ENGINE _ 62 90\.\ [ SPARK ARRESTER KIT i engine-tex...
Page 35
TRACTOR MODEL NUMBER 917.287540, PRODUCT YTH2246 ENGINE PART DESCRiPTiON Engine Briggs Model No, 441777 532 14 97-23 Muffler 532 19 43-20 Keeper Belt Engine 532 40 54-72 Pulley Engine 532 40 74-89 Tank Fuel 532 19 77-25 Cap Asm 532 17 83-85 Control Throttle 5321916-11 Screw 10 x 3/4 Single Lead Hex 537 19 15-96 Control Choke...
Page 36
TRACTOR MODEL NUMBER 917.287540, PRODUCT YTH2246 SEAT ASSEMBLY seat-tex 7A-vgt PART PART DESCRiPTiON DESCRiPTiON 532 19 75-18 Seat 873 80 05-00 Nut, Lock 5/16-18 unc 532 19 76-61 Handle Slide Seat 532 18 01-66 Bracket Pivot Fender 532 14 06-75 Strap, Asm Fender 532 19 82-00 Spring Latch Seat 8747606-12 Bolt Fin Hex 3/8-16 unc x 3/4...
Page 40
TRACTOR - - MODEL NUMBER 917.287540, PRODUCT YTH2246 STEERING ASSEMBLY _ji66 PART PART DESCRiPTiON DESCRiPTiON 873 94 08-00 532 19 39-43 Wheel, Steering Nut Hex Jam Toplock 1/2-20 unf 532 18 89-67 Washer Hardened Axle Asm., Front 532 19 59-68 .793 x 1.637 x .060 532 40 30-87 Spindle Asm., LH...
Page 41
TRACTOR MODEL NUMBER 917.287540, PRODUCT YTH2246 MOWER LiFT /" b-- /i lift-tex 5 r3 PART PART DESCRiPTiON DESCRiPTiON 532 19 42-08 Pin Cotter 5/16 Bow Tie Lock 532 19 52-23 Shaft Asm., Lift 532 19 51-81 Link Lift Susp Mower Rear 532 19 52-31 Lever Asm., Lift Rh 817 06 06-12 Screw 3/8-16 x .75 Smgml Tap/R.Z 532 41 15-55 Grip, Lever...
Page 42
TRACTOR - - MODEL NUMBER 917.287540, PRODUCT NO. YTH2246 TUFFTORQ TRANSAXLE MODEL NUMBER K46BT E_.PD MODEL K46BT 7A646084180 ACTUAL PARTS _--86 MAY NOT APPEAR AS SHOWN .........
Page 43
TRACTOR - - MODEL NUMBER 917.287540, PRODUCT NO. YTH2246 TUFFTORQ TRANSAXLE MODEL NUMBER K46BT PART DESCRIPTION 414395 VENT VALVE 15 414396 MAGNET 414397 MAGNET HOLDER 415923 PUMP SHAFT/BEARING 414398 BYPASS LEVER 414399 SEALING CAP 30 414400 SNAP RING C 35 414401 O-RING 1A P1OA...
Page 44
TRACTOR - - MODEL NUMBER 917.287540, PRODUCT NO. YTH2246 BRIGGS AND STRATTON ENGINE - MODEL NO. 441777-0726-E1 929A1' 10!' 968_467_ 213_ 1330 REPAIR MANUAL 1036 EMISSIONS LABEL 1329 REPLACEMENT ENGINE 1058 OPERATOR'S MANUAL 27 O_ 1040 703 _)_ 305A_ 27 O ]741 447A$ 447A...
Page 51
SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION ONLY RIDE UP AND DOWN HILL, NOT ACROSS HILL 15 DEGREES MAX. down the face of slopes, never across the face. Do not mow WARNING: To avoid serious injury, operate your tractor up and slopes greater...
Page 52
usqvarna Printed in the U.S.A, 532 41 06-89 Rev. 3 04.17.08 AP/TH...