Page 1
HOOVER_ FoldAway Upright Thank you for your purchase! Owner's Manual ENGLISH -I, pp. 1-12 ESPANOL -I, pag. 15-21 FRANGAIS -i, p. 22-28 www.hoover.com...
Page 3
If you need any assistance: Visit our website at www.hoover.com. Click on the "Service" button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of service outlet locations (U.S. only) OR Call 1-330-499-9499 to speak with a representative...
Page 5
Transporting cleaner Carrying handle Carpet height adjustment Put handle in upright position. Tilt Use the carrying handle to lift the cleaner back on rear wheels. Push cleaner. The cleaning of carpet and rugs takes forward. place at the nozzle (B). When it is necessary to raise and lower the nozzle for various carpet pile heights, turn the carpet height adjustment knob (C) to...
Page 6
Cleaning tools Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas. The cleaner is ready for tool use when handle is in upright position. CAUTION: Agitator continues to rotate while cleaner handle is in upright position.
Page 7
Familiarize yourself withthese home When to empty maintenance tasks a sproper useand It is recommended that the dirt cup be careofyour c leaner will e nsure c ontin- emptied before the dirt reaches the dirt uedcleaning e ffectiveness. opening on back of dirt cup (Fig. 4-2) or after every use if preferred.
Page 8
Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, HOOVER part No. 27313107. _5J_1 Disconnect cleaner from electrical Pull old bulb straight out of socket. Snap access door into place. outlet.
Page 9
Belt replacement The belt on your Hoover cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the hood of the cleaner and should be checked from time to time to be sure it is in good con- dition.
Page 10
3= Refer to "Clearing blockages" section. When purchasing a new agitator, ask for 4. When cleaner is unplugged HOOVER part no. 48414110. the motor sools for 30 minutes, thermal protector automatically resets The motor is equipped with bearings and cleaning may continue.
Page 11
• Allow cleaner to cool for 30 minutes service outlet locations (U.S. only). (this will reset the thermal protector) (see pg. 10). Do not send your cleaner to The Hoover Company in North Canton for service, Possible cause this will only result in delay.
Page 12
Authorized VVarranty Service outlets. Proof of purchase will be required before service is rendered. 1. Hoover Factory Service Centers 2. Hoover Authorized Warranty Service Dealers (Depots) For an automated referral authorized...
Need help?
Do you have a question about the FoldAway and is the answer not in the manual?
Questions and answers