Hose/Tool Caddy; Hose; Stair/Upholstery Nozzle - Hoover SteamVac F7428-900 Owner's Manual

Carpet cleaner description
i (,
,12
13
The assembled carpet cleaner will look like the drawing.
Model with SpinScrub
TM
hand tool is shown.
1. Hand grip
2. Solution trigger: press to release (:leaning
solution
3. ON/OFF switch
4. Rinse Setting switch
5. SpinScrub
TM
hand tool (not included with all
models)
6. Carrying handle
7. Clean water tank handle
8. Clean water tank
9. Detergent container
10. Recovery tank handle
11. Recovery tank: holds dirty solution
12. Recovery tank latches
13. Solution tube connection port
14. Brush setting selector
15. Edge cleaners: provided on both sides of nozzle to
remove dirt near baseboards
16. Nozzle
17. Hose connection port
18. Cord hook: rotates for quick cord release
19. Hose
20. Hose/tool caddy
21. Stair/upholstery nozzle
22. Bare floor tool (available at additional cost if
not included with your (:leaner)
23. Cord/hose hook
24. Handle release pedal
This carpet cleaner is intended for household use.
Operate carpet cleaner only at voltage specified on
data plate on back of cleaner. Plug carpet cleaner
into a properly grounded outlet.
ON/OFF switch
To turn (:leaner ON, push switch down.
To turn cleaner OFF, push switch up.
Handle release pedal
Step on pedal (A) to lower handle to
operating position. Handle does not lock
into a single position but "floats" to allow
convenient operation.
#
To transport
To move your carpet cleaner from room
to room, put handle in upright and
locked position, tilt carpet cleaner back
on wheels and push forward.
Continued -_ 7