Table of Contents
Advertisement
Cable
Connection
Direct
or Using
Cable
Box
When
using
figure
C3
with
a non-scrambled
cable
system,
the VCR
Input
Selector
Switch
No. 1 and the 2 Way
Splitter
No. 2 can be omit-
ted,
along
with
the coax
interconnecting
the
two.
Connect
the VCR Input directly to splitter
No. 1, and the cable box Output
directly to A/B
switch
No. 2.
Function of Acce6sorie$
2 Way Splitter No. 1: Divides the cable signal so
the signal is provided to the VCR and the Cable
Box.
A/B
Selector
Switch
No. 1, VCR Recording
Input Selector:
Used to select the Source for
VCR use.
In one position, the cable can be
recorded directly.
In the other position, the VCR
can record the Cable Box.
2 Way Splitter
No. 2: Divides the signal from
the Cable Box so the VCR can record it, or it can
be viewed on "IV.
A/B
Selector
Switch
No. 2, TV
Viewlng
Switch:
Used to allow the "IV to view the Cable
Box while the VCR is recording Direct cable
sources. In the other position, TV can view VCR
Recording or Playing.
(VCR/TV
switch of video
tape recorder must be in VCR mode,)
Operation:
After completing connections, set
A/B No, 2 to A position. Verify cable channels
to TV.
In this position, the TV and Cable Box
can be used as previously, except when making
unattended recording of the Cable Box.
Then
the Cable Box power must remain ON.
To view
what the VCR is Recording or playing, set the
switch to position B.
Tune the TV to the VCR
output channel, and set the VCR/TV
Switch to
the VCR mode.
Operation
of VCR
When the VCR Input Selector Switch A/B No. 1
is in position A, the VCR can record the Cable
Box. One channel position of the VCR should be
set to tune the Cable Box.
Channel position 01
is recommended.
Set the VCR as in the section
for Using Cable Box Only, when using position A.
When the A/B No. 1 is in position B, the VCR
operates as indicated in Direct Connection to
Cable.
Refer to Setting channels for Cable.
Remember that when making a Timer Recording
using the Cable Box, the Cable Box channel must
beprogrammed
into the Timer, the A/B No. 1
Switch must be set to A, and Cable Box power
must be left ON.
When recording the Cable
directly, be sure to set the switch to position B.
The VCR cannot select between the Cable Box
and Direct Cable inputs, so unattended record-
ings of both sources alternately should not be
programmed
unless someone is available to
change the setting of switch A/B No. I during
Timer operation.
VIDEO
CHANNEL
SETTING
The RF converter changes the video and audio
signals from the tuner or tape playback, to a stan-
dard television broadcast signal on channel 3 or
4.
To obtain video recorder output on either
channel 3 or 4, set the RF converter switch to
CH3 or 4 whichever channel is unused in your
area.
/
RF converter switch
NORMAL TV VIEWING
You do not need to disconnect VCR from your
TV set to watch TV.
When you turn off the
POWER switch on your VCR, the VCR automati-
cally switches to "'IV".
To watch TV, turn on TV and select a channel as
usual.
E16
Advertisement
Table of Contents
