Reversingthe Doorhandles - GE TBX18SABKLAA Owner's Manual

Reversingthe hardware.
Read these instructions completely and carefully.
Transfer Bottom Hinge to the Left
[]Remove the base grille (if your refrigerator
has one) by pulling it straight out.
[]Using a Torxdriver, move the bottom hinge
bracket (and shim glued to it) and plastic
washer from the right side to the left side.
HingeBracket
Plastic Washer
Transfer Top Hinge to the Left
Interchange hinge (and the shim glued to it)
and screws at top right with screws at top left of
cabinet.
Do not tighten screws on hinge side at this time.
Some hinges have four holes. Which holes you
use for installing the hinge depends on which
side you install the hinge.
The outer edge of the hinge should be parallel to
the edge of the case for correct installation.
Reversingthe doorhandles.
thstafling thehinge on theleft.
Instaflingthe hingeon the right
Read these instructions completely and carefully.
Transfer Fresh Food Door Handle
[]Remove the handle plug using a tape-tipped
putty knife under the edge, and remove the
screw underneath.
[]Remove the two screws holding the handle to
the top of the door.
[]Remove the handle.
[]Remove the screws from the right edge of the
door top and insert them into the handle
screw holes on the opposite side.
[]With tape-tipped putty knife or thin-blade
screwdriver, pry out the plug button from the
hinge hole on the left side of the door and
insert it into the hole on the opposite side
that was vacated by removal of the top hinge.
[]Pull the plug button from the front of the
door and transfer it to the opposite side.
®
®
Plug Button
Toreattach the handle on
20 the opposite
side.