Installation Instructions - GE GSS25WGMCWW Owner's Manual And Installation Instructions

Installation
Instructions
Refrigerator
Models 20, 22, 25
Questions ? Call 800-GE-CARES (800-432-2737)
or Visit our Website at:
www.GEAppliances.com
In Canada, call 1-800-361-3400 or Visit ourWebsite at:www.geappliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
"IMPORTANT
- S.ve t hese
instructions for local inspector's use.
. IMPORTANT - Obse,,,e all
governing codes and ordinances.
* Note to Installer
- Be sure to leave these
instructions with the Consmner.
* Note to Consumer - Keep
these instructions
for fimlre reference.
* Skill level - Installation of this appliance requires
basic mechanical skills.
* Completion time - Refrigerator Installation
15 minutes
* Proper installation is tile responsibility of tile
installer.
* Product failure due to improper installation is not
covered under the Warranty.
WATER SUPPLY TO THE ICEMAKER
(on some models)
If tile refrigerator has an icemaker, it will have to be
connected to a cold water line. AGE water supply kit
(containing robing, shutoffvalve, fittings and
instructions) is available at extra cost from your dealer,
by visiting our Website at _,GEAppliances,com
(in Canada, at _.geappliances.ca) or from Parts
and Accessories, 800-626-2002.
REFRIGERATOR LOCATION
• Do not install tile refrigerator where tile temperature
will go below 60°F (16°(;) because it will not run often
enough to maintain proper temperatures.
• Install it on a floor strong enough to support it fiflly
loaded.
CLEARANCES
Allow tile following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
• Sides 1/8" (4
HIHl)
• Top 1" (25
HIHl)
• Back 1" (25
HIHl)
A door clem'ance of 3/4" (19 ram) is needed fbr a 90 °
door opening which provides better access to the food
storage m'ea.
ROLLERS
The rollers have 3 purposes:
• Rollers adjust so tile door closes easily when opened
about halfivay.
• Rollers adjust so the refrigerator is firmly positioned on
the floor and does not wobble.
• Rollers allowyou m move the refiigeramr away from
the wall for cleaning.
To adjust the rollers, remove file base grille by pulling it
out at file bottom.
Turn file roller adjusting screws clockwise to raise file
refrigerator, counterclockwise to lower it. Use an
adjustable _wench (3/8" hex head bolt) or pliers.
To replace base grille, line up tile clips on back of grille
between tile bar and tile bottom of the cabinet. Push
forward until grille snaps into place.
14