Hitachi AX-M20EBS Instruction Manual page 4

Table of Contents

Advertisement

PRECAUTIONS
• If no sound is emitted from the speakers when the volume is raised, lower the volume, switch
the STANDBY/ON button to STANDBY, and check to see if the speaker cords are properly
connected.
• This unit contains a muting circuit and it takes about 2 – 4 seconds until this unit reaches stable
operation after switching the STANDBY/ON.
• Never open the covers or touch the inside or insert a metal objects. Any of these could cause an
electric shock or a fault.
• When thunder starts, unplug the power cord and disconnect the antenna.
• The apparatus shall not be exposed to dripping or splashing.
• To clean cabinet and panels when dirty, clean off dirt on the surfaces with a dry cloth. Never use
thinner, benzene or alcohol, for these will damage the surface finish.
• Protect the unit against excessive heat (e.g. direct sunlight), dust and moisture.
• Discs which can be played on the CD player have the following mark on them:
• Be carefull not to damage the power supply cord. Be sure to hold the plug when pulling it out; do
not pull the cord.
• Do not install the set in a confined location; otherwise, heat dissipation will be poor and
malfunctions may occur.
• Do not place foreign objects in the disc compartment. It may cause damage to the mechanism.
• Do not move the sound system suddenly from a very cold room into a warm room. When a
chilled CD player is moved suddenly to a warm location, condensation may form on the pickup
lens, preventing proper operation. In this case, wait 1 – 2 hours before resuming play.
• During playback, if the CD player is subjected to a sudden shock or jolt, some noise may be
produced. This is not a malfunction.
• The CD player has wide dynamic range. As a result, if you turn your amplifier's volume up too
high during soft (low volume) parts of a program, your speakers may be damaged when the
dynamic range of a sudden loud passage is produced.
• Do not store discs in high-temperature, high-humidity locations. The discs may develop warps
and become unable to play. Also, discs with moisture on them may be unplayable. Wipe any
moisture off with a soft, dry cloth, and be sure discs are fully dry before using.
• Do not leave a disc inside the CD player when it is not used for a long period.
• Please do not use compact discs with cellophane or with labels attached or those CD with
peeled off stains, such as rental CD. If such discs were used on a CD player, they may get
trapped inside the unit and cause malfunction.
• CD with special shapes (heart-shaped CDs, octagonal CDs etc.) cannot be played on this set.
Attempting to do so may damage the set. Do not use such CDs.
SAFEGUARDS
Electrical energy can perform many useful functions. This unit been engineered and
manufactured to assure your personal safety. Improper use can result in potential
electrical shock or fire hazards. In order not to defeat the safeguards, observe the
following instructions for its installations, use and servicing.
INSTALLATION
Avoid the use of this unit in high temperature areas (such as near heating equipment)
or in direct sunlight. Do not block the unit from radiating heat.
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ax-m20e

Table of Contents