Philips hid lamps and gear user manual (172 pages)
Summary of Contents for Philips Lightolier IS-PTS7
Page 1
IS-PTS7 Lighting Systems Cross Section 11”-1/4” 7”-1/16” +1/8“ 9” -0“ Ceiling Tile Ceiling Opening 9”- 7/32” Wall We reserve the right to change details of design, materials and finish.
Page 2
IS-PTS7 Lighting Systems SAMPLE PART LIST Note: Cartons are Shipped with the Following Components (Fig. 1) Wire Set Aligner Spline Standard Left hand Standard Reflectors Figure 1 Standard Fixture End Plate Kit Tele-Fixture Inside/Outside Corner Note: Facing wall, normal sequence of hanging fixtures is from left to right. Beginning with the longest fixture first and decreasing in fixture length to the right with the tele-fixture last.
Page 3
IS-PTS7 Lighting Systems STRAIGHT RUN INSTALLATION Fasten right hand end plate as in step 2. Screw Standard Screw Aligner Spline Washer Figure 2 We reserve the right to change details of design, materials and finish.
Page 4
IS-PTS7 Lighting Systems STRAIGHT RUN INSTALLATION (CONT’D) For Runs Ending in 3 or 4 Foot Fixtures before For Runs NOT Ending in 3 or 4 Foot Fixtures before Telescoping Model Telescoping Model Lamp Side Side Wall Wall Figure 3A Lamp Lamp Figure 3B We reserve the right to change details of design, materials and finish.
Page 5
IS-PTS7 Lighting Systems STRAIGHT RUN INSTALLATION (CONT’D) Wall Figure 4 Figure 5 Slide Lower Lamps Figure 6 Figure 7 We reserve the right to change details of design, materials and finish.
Page 6
IS-PTS7 Lighting Systems TELE-FIXTURE PREPARATION - ONE LIGHT RUN (Note: The over all length of the tele-fixture plus the right hand end plate must match the distance between the last hanging fixture and the wall.) (Note: To stagger the lamps, the blank channel on both the tele-fixture and the fixture before the tele-fixture may have to be measured to cut as shown in Fig.
Page 7
IS-PTS7 Lighting Systems TELE-FIXTURE PREPARATION - TWO LIGHT RUN (Note: The over all length of the tele-fixture plus the right hand end plate must match the distance between the last hanging fixture and the wall.) Wall Wall Figure 10 Figure 11 Screw Figure 12 Figure 13...
Page 8
IS-PTS7 Lighting Systems PATTERN RUN INSTALLATION Note: Read straight run installation instructions before installing pattern run. Starting from left to right facing the wall, install the reflectors. Figure 14 Faceted Reflector Note: Do not fasten fixtures to the wall with the adjustable mounting brackets until all fixtures, corners and tele-fixtures are installed. We reserve the right to change details of design, materials and finish.
Page 9
IS-PTS7 Lighting Systems RELAMPING PROCEDURE Step 1. Louver Removal Step 2. Relamping Figure 15 Wall Side Step 3. Louver Installation Room Side Step 4. Test - LOUVER MUST BE LEVELED Reflector Figure 16 Flange Figure 17 Figure 18 Figure 19 We reserve the right to change details of design, materials and finish.