General Maintenance; Lubrication - Craftsman BRUSHWACKER 636.795454 Owner's Manual

Line & Spool Maintenance [€ont'd]
GENERAL MAINTENANCE
A. LUBRICATION
FOLLOW INSTRUCTIONS! After every 10 hours of
operation, remove the plug and fill gear box with grease,
4,
Figure 24
There are two eyelets, one on each side. After the
nylon cord has been threaded through eyelets
with thick side facing shaft holt, (may not be ap-
plicable on all heads), insest eyelets in side slots of
housing while inserting interspool. Thus snapping
together both interspool and eyelets in housing
with one motion. Clip ends of nylon to equal
lengths. Thread knob back on shaft and retighten.
See figure 25.
Figure 26
ASE
Removing the Trimmer Head
To remove the Trimmer Head( nylon cutting head )do this:
Align the hole in the lower head with the hole in the cup
washer. Insert the Lock Handle which is included in the
BRUSHWACKERT.M. tool kit thru the hole as shown
thus locking the drive shaft. Holding on to the Lock
Handle, unscrew the Universal Head by turning in the
direction shown.
Caution:
Figure 25
Nylon cutting cord must be one conti-
nuous length, with interspool centered!
If separate pieces are used on each side
serious injury may result as you near the
end of use on nylon cord.
Eyelets must be used or the line can cut
through the spool housing and possibly
destroy the operation of the nylon
cutting head.
TURN THIS WAY TO REMOVE. "
LOCK HANDLE
Provided in tool kit.
Figure31 Key 24 on page 18.
Figure 27
!1