Advertisement
WARNING:
Always remove battery pack from
your saw when you are assemblingparts, making
adjustments,assembling or removingblades,
cleaning, or when not in use. Removing battery pack
will prevem accidental startingthat could cause
serious personal injury.
Note: Your saw is assembled with the battery pack
attached.
TO REMOVE BATrERY
PACK
See Figure 3.
•
Locate latches on side of be_ery pack and depress to
release battery pack from your saw. See Ffgure 3.
•
Remove battery pack from your saw.
DEPRESS LATCHES T O
RELEASE SATrERY PACK
TO
REMOVE
TO
LATCHES
BATFERYPACK
Fig. 3
TO ASSEMBLE OR REMOVE BLADE
TO ASSEMBLE
BLADE:
See Figure4,
WARNING:
A 5-1/2 in. blade is the maximum
blade capacity of your saw. Never use a blade that is
too thick to allow outer blade wssher to engage with
the flats on the spindle. Larger blades will come in
contact with the blade guard, while thicker bladeswill
prevent blade screw from securing blade on spindle.
Either of these situationscould result in a serious
accident.
•
Remove battery pack from sew.
WARNING:
Failure to remove battery pack from
saw could result in accidental starting causing
possibleserious personal injury.
•
Locate latcheson side of battery pack and depressto
release battery pack from yoursaw. See Figure3.
SPINDLE
LOCKBg'TTON
LOWIERBLADE
GUARD HANDLE
BLADE
F
MNER
BLADE WASHER
BLADESCREW
Fig. 4
•
Remove blade wrench (5 mm hex key) from storage
area. See Figure 1.
•
Depress spindle lock button and remove blade screw
and outer blade washer. See Figure 4.
Note: Turnbladescrewclockwiseto remove.
•
Wipe a drop of oil onto inner blade washer and outer
blade washer where they contact blade.
WARNING:
If inner blade washer has been
removed, replace it before placingblade on spindle.
Failure to do so could cause an accidentsince blade
will nat tighten propedy.
•
Fit saw blade inside lower blade guard and onto
spindle.
Note: The saw teeth point upward at the front of saw
as shown in figure 4.
•
Replace outer blade washer.
•
Depress spiridlelockbutton, then replace blade screw.
"lightenblade screw securely.
Note: Turn blade screw counterclockwise to tighten.
•
Return blade wrench to storage area.
REMEMBER: Never use a blade that Is too thick to
allow the outer blade washer to engage with the flats
on the spindle.
11
Advertisement
