Fence Height Adjustment; To Adjust Height Setting; Fence Rotation/Angle Adjustment - Craftsman 315.175500 Owner's Manual

FENCE HEIGHT ADJUSTMENT
See Figure 5.
HEIGHT
ADJUSTMENT
KNOB(S)
_k WARNING: Failure to unplug your Detail Biscuit
Joiner could result in accidental starting causing
possible serious personal injury.
TO HEIGHT
LOWERFENCE SETrlNG SCALE
Fig. 5
The fence on your Biscuit Joiner can be moved up and
down to adjust the position of the blade in relation to
the top of the workpiece. A scale on both sides of the
front base indicates height settings for both 45 ° and
90 ° angles. The fence and height indicator mark can
be positioned from 5/16 in. to 13/16 in. from the center
of the blade for 45 ° angles. It can be positioned from 0
to 3/4 in. from the center of the blade for 90 ° angles.
Scale marks are in increments of 1/16 in.
TO ADJUST HEIGHT SETI'ING
See Figure 5.
• Unplug your Detail Biscuit Joiner,
_k WARNING: Failure to unplug your Detail Biscuit
Joiner could result in accidental starting causing
possible serious personal injury.
• Loosen the two height adjustment knobs.
• Pull the fence forward and slide it up or down until
the height indicator mark is aligned with the
desired dimension on the scale.
Note: Slots in the front base align with a tab on the
backside of the fence. See Figure 6. This align-
ment keeps the fence square at each height
setting,
• Tighten height adjustment knobs securely.
FENCE ROTATION/ANGLE ADJUSTMENT
See Figure 6.
The fence on your Biscuit Joiner can be rotated 180 °
and set at either 45 ° or 90 ° angles.
TO ROTATE FENCFJCHANGE ANGLE SEI"rlNG
See Figure 6.
• Unplug your Detail Biscuit Joiner.
ADJUSTMENt
KNOBS
(I) PULL
FORWARD
_IP FENCE
(2) SLIDE
DOWN
;"o'.'
_ HEIGHT
ADJUSTMENT
KNOBBOLT(S)
FRONT
BASE
SLOTS"
KEY
HOLE SLOTS
FRONT
FENCEORIENTATION SLOT(S) BASE
FOR 90° ANGLES Fig. 6
• Loosen the two height adjustment knobs.
• Pull the fence forward and slide it down the front
base until it can be removed through the key hole
slots.
• Rotate the fence 180 °.
• Reinstall the fence on the front base. Place height
adjustment knob bolts in key hole slots and align
bolt heads with the slots on back of front base.
• Slide fence up the front base to desired depth of
cut.
• Tighten height adjustment knobs securely. See
Figure 6.
11