Page 1
6.5 Horsepower HIGHWHEEL WEEDTRIMMER KEY START MODEL 536.773521 Caution: Read and follow all Safety Rules and Operating Instructions before first use of this product, SEARS,F_0O0211MROEBUCK AND CO., Hoffman Estates, IL 60179 U.S.A.. I...
STATEMENT LIMITED TWO-YEAR WARRANTY ON CRAFTSMAN WEEDTRIMMER For two yearn from the date of purchsse, when this Craftsman Weedtdmmer is maintained, lubricated, and tuned up according to the operating and maintenance instructions in the owner's manuat, Sears will repair, free of charge, any defect in matadal or workmanship.
Page 3
SAFETY RULES Safe Operation Practices Trimmer. WARNING: Look for this symbol to point out important safety precautions. It means: "Attention! Become Alertl Your Safety Is Involved," I. General Operation Only usa accessories approved by the manufacturer. Read, understand, and follow all instruc- 15.
SAFETY RULES Never refuel the machine indoors. slopes require extra caution. If you feel uneasy on e slope, do not trim it. Dotdm across the face of slopes; never up end Never store the machine or fuel con- down. Do not trim excessively steep slopes tainer inside where there is an open (maximum 15 degrees) or areas where the flame, such as a water heater.
SAFETY RULES INTERNATIONAL SYMBOLS IMPORTANT:Many of the following symbols are located on your unit or on literature sup- plied with the product. Before you operate the unit, learn and understand the purpose for each symbol. Slow Fast Fuel OOlO_ eOOGOOGOOO OOGO WARNING WARNING...
ASSEMBLY ASSEMBLY CONTENTS OF PARTS BAG Owner'sManual - Parts Bag Not shown actual size) 2 Sets 1 - T--Handle 1 - Safety 1 - 20 oz. Trimmer Lines 1 - Battery Wrench Glasses Bottle Oil (0.155 inch diameter) Charger TO REMOVE THE WARNING: Always wear safety...
Page 7
ASSEMBLY HOW TO RAISE THE HANDLE Hold the handle with one hasd asd loosen both handle adjustment knobs untU the ratchet teeth are disengaged. Do not remove the handle adjustment knobs. See Figure 2. Raise the handle to the operating position. Stand in the operator's Handle position behind the trim-...
Page 8
ASSEMBLY ENGINE PREPARATION Fill Crankcase With Oil The trimmer was shipped with a container of SAE30 motor oil. This oil must be added to the engine before operating. Oil Fill Cap/ Dipstick Remove the oil fin cap/dipstick shown in Figure 4. Fill the crankcase to the FULL line on oil fill cap/dipstick.
OPERATION KNOW YOUR TRIMMER READ THE OWNER'S MANUAL AND ALL SAFETY RULES BEFORE YOU OPERATE the trim- mer. To familianze yourself with the location of the controls, compare the illustrationswith your trim- mer. Save this manual for future reference. Control Bail Tdmmer Head Drive Lever Ignition Switch Throttle Control Lever...
Page 10
OPERATION HOW TO USE THE TRIMMER HEAD DRIVE LEVER Control Bail To engage the trimmer head, hold the con- Handle trol bail against the handle. Move the trimmer heed drive lever forward to en- gage the trimmer head. See Figure 6. The faster the engine runs, the faster the trim- mar head will rotate.
Page 11
OPERATION BEFORE STARTING THE ENGINE How To Fill With Gasoline Oil Recommendation Only use high qualitydetergentoil ratedwith NOTICE: ENGINES WHICH ARE CERTI- API serviceclassification SG. Selectthe oil's FIED TO COMPLY WITH CALIFORNIA AND US EPA EMISSION REGULATIONS SAE viscositygrade according to your ex- pected operatingtemperature: ULGE ENGINES: Are certified to operate on...
Page 12
OPERATION HOW TO START THE ENGINE NOTE: DO NOT BE ALARMED, your engine Figure10. Pullbacksharplyon the recoil will smoke the first time it is started. It is starter handle. DO NOT allowthe starter burning offthe protectivecoating that is on rope to snap back. Let the starter rope the internal engine parts.
MAINTENANCE CUSTOMER RESPONSIBILITIES oooo_o_mooooeo eom_ eooMo oooN oeeeo OUmONO_O_mOO • eOOO oooo_o o qlll__ • • _ • Ill4' _ • • =oe_ eeew eee_ ee_e ooooo Check trimmer Lines Engine/Machine Cleaning Check Spark Plug Service Air Filter Lubricate Wheel Bearings Note 1 - When old line is half the original length, replace with new line.
Page 14
MAINTENANCE LUBRICATION How To Lubricate The Jackshaft Assembly A grease fitting is provided to lubricate the jaskehaft assembly. Use a grease gun with au- tomotive type grease to lubricate the jackshaft assembly as shown in Figure 11. How To Change Engine Oil Change the engine oil when the engine is Connect the spark plug wire to the spark wam'l.
Page 15
MAINTENANCE HOW TO SERVICE EngineDebrisShield THE ENGINE AND SPARK PLUG To acsess the engine or the spark plug, re- move the engine debds shield as shown in Figure 14. After engine service is completed, replace the engine debris shield. Wingnut Figure14 SPARK PLUG Tightenthe spark plug to a torque of 15...
SERVICE AND ADJUSTMENT SERVICE AND ADJUSTMENT Make sure that all moving parts have stopped. Disconnect the wire from the WARNING: Before you inspect, clean or service the trimmer, stop the engine. spark plug. HOW TO REPLACE THE TRIMMER LINE For the best performance, use a heavy Tdmmer Line Shield gauge (0.155"...
Page 17
SERVICE AND ADJUSTMENT HOW TO ADJUST THE HEIGHT OF THE HANDLE Handle Use the knobs, on each side of the handle, to Ratchet adjust the height of the handle. Hold the handle with one hand and loosen both knobs until the ratchet teeth are dis- engaged.
Page 18
SERVICE AND ADJUSTMENT HOW TO TrimmerHousing REPLACE THE DRIVE BELT To reptase the dr_ve belt, the trimmer head and shield must be mmovod as follows. the drive belt, disconnect the wire WARNING: Before you remove from the spark plug. Remove the two fasteners that hold the rear of the shield to the trimmer housing (See Figure 19).
Page 19
SERVICE AND ADJUSTMENT HOW TO CHARGE THE BATTERY Charge the battery for 16-24 houm. Disconnect the battery charger from the WARNING: The battery contains electrical outlet and from the battery. sulfuric acid which is harmful to 5. Connect the wiring harness to the bat- the skin, eyes end clothing, ff acid tery.
Page 20
Put the trimmerin a building thathas good ventilation. If you do not want to remove gasoline, add a fuel stabilizer, such as Craftsman fuel NOTE: A yearly checkup or tune-up at a stabilizer No. 33500, to any gasoline left in Sears authorized service center will make the tank.
TROUBLE SHOOTING CHART TROUBLE CAUSE CORRECTION Engine does not start Spark plug wire Connect spark plug wire. disconnected. Prime engine. Engine not primed. Defective or incorrectly Inspectorreplacespark gapped spark plug. plug. Add fuel, Fuel tank empty. Clean carburetor orfuelline. Dirty carburetor or fuel tine. Dirty air filter.
Page 22
TROUBLE SHOOTING CHART Engine overheats. Engine cooling system Clean debris screen and , clogged, engine cooling fins. Carburetor out of adjustment. Adjust carburetor. Take the unit to a Sears Service Center. Oil level is low. Add oil. Defective throttle contm! Engine will not stop Inspect and replace lever or wire.
SLOPE GUIDE SIGHT AND HOLD THIS GUIDE LEVEL WITH A VERTICAL TREE, A CORNER OF A STRUCTURE, A POWER LINE POLE, OR A FENCE. Operate a trimmer across the face of slopes, never up or down slopes. Use this guide and do not trim on a slope greater than 15 degrees. A 10 degree slope is a hill that increases in height at approximately 1.7 feet in 10 feet..
For the repair or replacement parts you need delivered directly to your home Call 7am-7pm, 7days a week 1-800-366-PART (1-800-366-7278) Para ordenar piezas con entrega a domicilio - 1-800-659-7084 For in-house major brand repair service Call 24 hours a day, 7days a week 1-800-4-REPAIR (1-800-473-7247) Para pedir servicio...