Operation; To Install Batteries; To Turn The Tool On; Using The Glasses Included - Craftsman 320.48251 Owner's Manual

TO INSTALL BATTERIES (See Figures 2 and 3)
This Laser Trac
TM
Level uses two "AA" batteries,
IMPORTANT: BEFORE installing the batteries, ALWAYS
the on/off switch on the level is in the up off position (see Fig. 2)°
Fig. 2
up-elf
down-on
,2
Fig. 3
check to be sure that
1. Turn the black battery cover plate on the back of the level 1/4 turn in a
counterclockwise direction and remove cover (see Fig. 3).
2, Install the batteries with the polarity as indicated on the label in the battery
compartment,,
3. Place the black cover plate back onto the tool and turn the plate 1/4 turn in a
clockwise direction to lock,
TO TURN THE TOOL ON (See Figure 4)
The switch to turn the Laser Trac
TM
Level on is located on the front of the toolo
1, Move the switch down to its lowest level to turn on the laser°
z_WARNING: When turning on the Laser Trac
TM
Level ALWAYS be aware
of protecting the eyes of yourself and those around you°
NEVER point the Laser Trac
TM
Level at anyone's face, including your own.
2, To turn tool off, move switch
all the way up until it locks in the up
position,
Using the Glasses Included
Fig. 4
This level includes a pair of standard ._
safety glasses that are made of a laser
light enhancing material.
The primary purpose of these glasses
is to improve the viewing of the tool's laser lineo
Z_WARNING: These glasses WILL NOT protect the eyes from damage that
could result from looking directly into the laser projection,
5