Replace Fuel Filter - Craftsman 358.351141 Operator's Manual

CUSTOMER RESPONSIBILITIES
REPLACE FUEL FILTER (Fig. 33, 34, & 35)
The fuel filter should be replaced after each season.
Never operate your saw without a fuel filter. Be careful not
to damage fuel line while removing the fuel filter.
• Run fuel tank dry of fuel before proceeding with this
step.
• Remove fuel cap and allow it to hang to side of motor.
• Using a small pair ot needle nose pliers, grasp fuel cap
retainer, holding it in tank opening and pull out.
• With cap out of tank, use a small section of bent wire
similar to that shown in the illustration to catch fuel line
and slowly pull from tank. When fuel tilter appears in
opening, grasp with fingers and remove from tank.
• Once filter is out of tank, hold fuel line close to fuel fil-
ter. Remove fuel filter by twisting and pulling at the
same time.
• Replace fuel filter.
• Reverse process for installation.
Fill Cap
Figure 33
Fuel Line
Figure 34
Fuel Filter
Barrel
Filter Neck *''_ I_
Figure 35
Fuel Filter
"21 -