Craftsman 102.249020 Owner's Manual page 7

40-inch mower grass catcher
Table of Contents

Advertisement

Remove the right hand shroud from seat support.
Save all hardware except rear bolt and nut.
Replace these with the new bolt and nut from
Group F and set the bolt, nut and washer aside.
Seat Support_
Right Hand
,Shroud
,Discard Nut
5_
Mount bagger frame to rear of tractor using 1/2"
bolt & nut from Group C. Snug up bolt and nut but
do not tighten at this time. This will hold bagger
frame to tractor frame, but still allow it to move
slightly to align other mounting hardware. Ensure
support strap is inside seat support.
9.
Install the bolt, washer and nut set aside in step 4
through the seat support and support strap. Do not
I
t=ghten or snug up, leave loose.
10. Tighten a!l hardware in the following order:
(a) 1/2 bolt & nut in rear
(b) 5116 bolts & nuts in trailer hitch (4)
(c) 3/8 bolts & nuts on R.H, side (4)
(d) 3/8 bolt & nut on trailer hitch and hitch brace
(e) 3/8 bolt in bottom of hitch brace (loosened
in step 3)
11. Remove the bolt, washer and nut holding the sup-
port strap to the seat support•
12. Reinstall the shroud with the hardware saved from
step 4. The bolt removed in step 11 should go
through the washer, shroud, seat support, then the
support strap.
13. Reinstall the dump valve knob and secure with jam
nut.
Bagger
Assembly
1.
Install cover assembly onto bagger frame. Use the
two 5/16 wingnuts and 1 hair pin (Group G).
j
Cover
Assembly
Frame
Trailer Hitch
Tractor Frame
Strap
Seat
Group C
F
Group E Trailer
........,..;
_
Hitch
........ i._;.,, o
Bagger
Brace
ignut
6.
Reinstall the trailer hitch on the rear of the tractor
behind the bagger frame. Use the four 5/16-18 x 1
bolts and nuts from group D.
7.
Use 3/8-16 x 1.25 bolt and Iocknut to fasten trailer
hitch to hitch brace. Snug up but do not tighten.
8.
Install the four 3/8-16 x 1 bolts (Group E) into right
side of bagger frame and tractor frame with lock-
nut. Snug up but do not tighten.
Hair Pined
2.
Install bagger baskets into cover assembly.
3.
Close cover and secure by placing hook through
eye bolt. See figure on next page.
7

Advertisement

Table of Contents
loading

Table of Contents