Check Motor Rotation - Craftsman 113.22521 Owner's Manual

MOTOR BASE CLAMP
SCREWS
1 Place the motor on your workbench with the 5/8 Dia
shaft (with key way) facing you
2 Loosen the two motor base clamp screws and rotate
the motor so that the ventilation holes are facing to
the side . tighten the screws
5/8"' DIA SHAFT
BELT GUARD
SUPPORT
BRACKET
THREAD
CUTTINGSCREWS
BELT GUARD
SUPPORT
3 Attach guard support to the bracket with the two
screws furnished with the belt guard
NOTE: The holes in the bracket are not threaded,
but the screws are "thread cutting screws" and will
cut a thread as they are tightened
SCREWS
4_ Loosen setscrew in motor pulley and place the pulley
on the shaft with the hub flush with the end of the
shaft, insert the motor shaft key and tighten setscrew
with 5/32" setscrew wrench
CHECK MOTOR ROTATION
The motor must rotate COUNTERCLOCKWISE when
viewed from the PULLEY end
1. Place the motor on your workbench or on the floor
2. Stand clear of the motor and plug the cord into a
properly grounded outlet (See page 5). Notice the
rotation of the pulley. If it is not turning COUNTER-
CLOCKWISE, REMOVE the plug from the outlet,
and change the rotation of the motor according to
the instructions furnished with the motor.
WARNING: FOR YOUR OWN SAFETY, MAKE
SURE PLUG IS NOT CONNECTED TOPOWER
SOURCE OUTLET.
5/32 INCH
SETSCREW
WRENCH
DIRECTION
OF
ROTATION
\
MOTOR
FLUSH HERE SHAFT
KEY
11