GE Monogram ZDBR240 Owner's Manual page 13

Built-In Dimensions
Beverag'e ( enl_,r
Installation
dimensions
Tile bexerage center can be a Dee-
standing model or can be buih in using
the cut-out dimensions below.
347{"
(876mm)
Product dimensions:
Height: 341/2" (876 ram)
'_A'idth: 23:%" (603 ram)
Depth: z:"/4 (60: ram)
NOTE:
Handle and
handle standoff
depth is 1:%"
When building in tile bmerage center,
be sure to allow tBr a flfll door swing so
you haxe flfll access to the pull-out flfll
extension drawers.
See the Installation Instructions (Pub. No.
49-60910) for complete directions.
Cut-out dimensions:
34/2-3a (876-889 ram)
Height: i r.,,
cl c_{ / t'z*
XA'idth: z_'/4 (603 ram) minimum
Depth: 94" (610 ram)
The bexerage center is t;actorv set for a
l l 0 ° door swing.
When installed in a corner:
• Allow 4" minimum clearance on the
hinge side for the 90 ° door swing and
to allow racks to slide out.
t! Allow l0 minimum clearance on tile
hinge side tbr a flfll 110 ° door swing.
Tile door swing is rexersible on all
models. If desired, change the door swing
before installation.
Choose the location:
These products may be closed in on the
top and three sides as long as tile front
is unobstructed for air circulation and
proper access to the door.
Do not install these products where the
temperature will go below 55°F (1, C)
or aboxe 90°F (, 9 C).
• Do not install where it will be subject to
direct sunlight, heat or moisture.
10" Minimum
to Wall
i
I t'
', ill,
110° .. \
90° DoorSwin(
, 21-5/8"
h
!
23-5/8"
90°
4" Minimum
to Wall
Black or Stainless Steel Toekick Options
These products are shii)ped with a black
toekick installed. All optional stainless
smel mekick is also supplied with each
product. For shii)ping purposes, the
stainless sine] toekick is secured to the
back of the unit.
13