Front Gate - Craftsman 610.243551 Operator's Manual

f
Body Half Assembly "" * ,
Lock Washer 5/16"
Inset A
FRONT GATE INSIDE I
Nut 5/16"
5/16" x 1/2" Pan
Bolt 5/16" x 1/2" Hex
Hex Nut 5/16"
Figure 1.
Inset B
_. NOTE: DO NOT TIGHTEN BOLTS UNTIL ALL CQ,M.,.P, ONENTS IN THIS STEP ARE IN PLACE. j
* Position Body Halves (1 & 2) as shown, front gate side up. Front gate side has fewer holes than tail gate side.
Assemble with four 5/16" x 1/2" Hex Head Bolts (24), 5/16" Lock Washers (23W), and 5/16" Hex Nuts (23N).
See inset B.
* NOTE: Front Gate is positioned INSIDE Cart Body.
"Lay assembled Body Halves down on floor. Add Front Gate (3), using eight 5/16" x 1/2" Pan Head Bolts (23).
with 5/16" Lock Washers (23W), and 5/16" Hex Nuts (23N).
* Add the two Corners (4) using four 5/16" x 1/2" Pan Head Bolts (23), 5/16" Lock Washers (23LW)
and 5/16" Hex nuts (23N). See inset A,
THIS STEP REQUIRES
I
42)- 5/16" x 1/2" Hex Bolt I
i t (16)- 5/16" x 1/2" Pan Head Bolt
- 5/!6" Lock Washer
- 5/16" Hex Nut
FOR MISSING PARTS, Call 1-800-652-2321, Mon- Frl, 8 a.rn. . 5 p.m.E.S.T.
Page 5