Advertisement
A
WARNING:
Read and understand all instructions.
Failure to follow all instructions
listed below may
result in electric shock, fire, and/or serious personal
injury.
Safe operation of this accessory requires that you read
and understand this operator's manual, the operator's
manual for the miter saw, and all labels affixed to the tool.
SAVE THESE
INSTRUCTIONS
READ ALL INSTRUCTIONS
•
KNOW YOUR ACCESSORY.
Read the operator's
manual carefully, Learn the applications
and limitations
as well as the specific potential hazards related to this
tool.
ASSEMBLING
THE STAND-n-STOW
TM
CABINET
See Figure 1.
This product requires assembly,
•
Insert the supplied lock nut into the hex nut pocket,
•
Align the reinforcement plate holes with the tab on the
bottom of the base and the screw hole in the base.
•
Place supplied washer and lock washer onto the
supplied screw,
•
Insert screw into the hole in the base.
•
Turn clockwise to tighten screw,
•
Repeat above steps until all four screws have
been inserted and tightened into base and both
reinforcement plates are installed.
HEXNUT
BASE
POCKET
o
Q
I
WASHER
REINFORCEMENT
PLATE
LOCKWASHER
-_SCREW
Fig. 1
MOUNTING
THE STAND-n-STOW
TM
CABINET
BASE TO THE LEG STAND
See Figures 2 - 4.
When the leg stand and Stand-n-Stow
TM
cabinet are not in
use, the leg stand can be folded up and placed in the leg
stand storage area as indicated in figure 4.
•
Place the leg stand on the floor then open the leg
stand by pushing opposite legs in opposite directions
as indicated by the arrows in figure 2.
Place the Stand-n-Stow
TM
cabinet on the leg stand.
Align the slots in the miter saw base with the slots on
the top of the leg stand,
•
Insert the tab on the Stand-n-Stow
TM
cabinet locking
knob into the slot on the leg stand.
• Turn the locking knob clockwise to secure the Stand-n-
Stow
TM
cabinet to the leg stand,
•
Repeat with the other three locking knobs.
1[
i
Fig. 2
Advertisement
